开云体育

Thanks Jonathan. Actually 18ga brads (less likely with 15 or 16 ga nail) can also come out the side if shot near the edge. This is much more likely if they are shot with chisel end along the grain

Interesting update on this table project. I've successfully dodged a bullet. In my research, I discovered the original photo I attached is built by an Interior Designer job shop in Wisconsin just a

Hi Quick update, It was in fact the toe out issue with the blade and we needed to nudge the slider away circa 0.2mm. This was done by opening the top 7 nuts on the slider, leaving the first infeed

Imran don't think this will be of help as my nailers are European.....but I have had a SIMES SA-F6-30 for many years. On the odd occasion a pin wont sink if its hit a knot or some hard grain. Also if

Watch this. https://youtube.com/shorts/Gong0ivu9XE?si=G7usN_T7Q8eKqzrH David

Here we go again, LOL Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

Thanks David. I am considering other brands. Appreciate if others share good/bad experiences with 23 ga pin nailers. Imran Malik IAM Wood

It's the wrong color. For Imran to upgrade doesn't it need to be a different color? Dave Davies [email protected]> wrote:

I have never had issues with my Omer PR.30 pin nailer not sinking the heads even in hardwoods. I HAVE had issues with my Grex 21 gauge nailer sinking heads consistently. Consider

Hi Mike, No I did not try that and Grex did not recommend it. It is boxed up now to go back. BTW, what I shared here was after it was reviewed by Grex. The smaller body is good for maybe 3/4” in

Hello Imran, Have you tried ?pressing one hand down on the ‘head’, while pulling the trigger with the other? My old Senco pinner requires this on longer pins, and especially 1 1/2” in

Philip, This could be a legitimate case of ? give forward ?… or a scam. Be careful. Regards, Jacques

Sorry folk, The lady who contacted me about free saw is actually in Vermont, not S.F. Bay Area. I just assumed she was local as she contacted me. Anyone in the Vermont area for a free piece of

That’s awesome Alan Jones Owner, HiFi Buys 770.931.0606 3157 Peachtree Rd NE | Atlanta, GA 30305 hifibuys.com Our highest goal at HiFi Buys is to create a customer experience that is outstanding;

Bill, I found this website https://www.suembroidery.com/. It is a Chinese company selling Su Embroidery outside of China. If you do visit China, you will want to visit this town (

Hi James, Thanks for the reply. It might help me find a place that sells just the embroidery pieces. May have to wait for a trip to China to actually find something. -- Bill Hope ( https://dnisw.com

Never mind the jointer, check out that tractor!! -- Kerry Smith Gotham Woodworks www.gothamwoodworks.com Yeah, and it's something I actually use... a lot! Bon

"Nice tractor, and easy access to the shop. I am almost envious. I had to pay $1,475 for a rigger to move my saw, and then another $625 to repair my lawn after the rigger drove over it. ? -- John

Hello fellow woody's. ?I received an email from a mom who lost her son and wants to give his Saw-stop table saw away to a passionate woodworker. ?Im in Napa Ca. so they must be nearby, so any of you

Nice tractor, and easy access to the shop. I am almost envious. I had to pay $1,475 for a rigger to move my saw, and then another $625 to repair my lawn after the rigger drove over it. ? -- John