开云体育

Mac - I hear you on that.? I disabled Siri on my iPhone, it is totally unnerving. cheers, Rich Markiewicz

I do not have dementia!! Somehow, a goofy phone was listening to myself and my friend Tom troubleshoot a problem on my lath which we fixed and have no idea how we fixed it that’s nerving anyhow

Looks like CMT 016 profile cutter's price is only 50% of the Dimar cutter's price from onlinesupply.ca. Doing woodwooding is really expensive in Canada. Btw, looks like Imran is looking for the

If you just want the standard commodity 40/50mm profile knives most places (including Amazon) carry them. The the number system is standardized. Cmt or amana will be common in the us. 016 knife:

?Wade great idea, I will be happy to sell my Design manufacturing fixtures and patterns a reasonable cost. Electric bolt underneath I don’t think there’s any bolts down there lift up again once

I bought some Dimar profile cutters and limiters from onlinesupply.ca https://onlinesupply.ca/Drilling-Cutting/shaper-cutters/multi-profile-cutters-shaper-cutters The profile cutters Felder offers are

Did you want limiters too?? Not all north American shops are familiar with them though some are.

Thanks Jared. Will contact him instead. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

That must be a different mt tool. Neil is in Baltimore. https://www.mttoolco.com/contact On the plus side he is extremely fast. I've had corrugated knives in less than 24 hours from emailing a drawing

Thanks Joe and Jared. MT Tools is in Schaumburg, IL and be great for me. Will contact them Monday. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Joe, you are correct, I've had Neil cut 40mm knives. [email protected]> wrote:

I’ve had Hot Knives make those. They can use the better and thicker steel also. Those heads will accept 1mm thicker than standard for the knife. I bet Neil at MT tool could as well.

Thanks Andy, that is in UK correct. Should have added, looking for a source in USA. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Whitehill tools [email protected]> wrote:

I have not checked with Felder as it is not going to be quick. Took them 6 weeks to get me limiters for a standard knife. These are also referred to as 64F series or 690 series and look like this I am

Hi Cornelius, It is a shame that you can’t mount PF to your Jointer. As to your concern about bow staying there due to PF, David Best and Lucky have addressed this here may be others too. In case I

Netanel, if you’re setting a toe-out on a sliding table in a stand alone shaper to avoid binding your reference should be your shaper fence as this is where the binding could happen. To make it

In general, on a shaper, you want the trajectory of the sliding table to be parallel with the fence plates on the shaper hood. This way you can use any point along shaper fence as a bump-stop

Thanks david, I watched your video again, but the toe-out of the slider is adjusted based on the table saw blade, but on a standalone shaper you don't have a blade, so what would you reference? Does

I believe that gap you see is an illusion because of the poor lighting/shadows. The corner edges of the tenoning plate are chamfered, and it is also relieved at both ends on the underside by about