开云体育

Consider yourself on of the lucky ones. Some people, like yourself, have a short crosscut fence setup that will come off and go back on and register square to the travel of the sliding table. However,

Nice work SImon. I think... What am I looking at??

Ok, i have to ask; What kind of tolerences are you expecting to achieve with the short crosscut fence? I have been using one on a fairly regular basis for particular jobs on the saw and spindle

Thank you David. I watched all the videos in your link. I also showed the CNC shop your video what I was there this afternoon. I? that explain? the required tight fit. tolerance? , he said it is

Yes, this is not as simple as making a precision T-nut. The thickness of tabs that overhang the T-slot on the Felder sliding table vary in thickness. For this reason, the T-nut must have grub screws

Hi John, they work well, the only issue you'll run into is guarding. The tenon hood isn't built for cutting rearward of the spindle, it's built for larger cutters forward of the spindle. Regards, Rod.

I was at a local CNC machinery for a small job I need. I asked them if they can produce the T-nut and bushing with the tight tolerance of less than 0.0005” and they confirm they can. I think to buy

Wow, that's nutz. Love it. Tom Ruth

These are 100% done with a 3D cut path on the CNC. Even the tiniest amount of sanding would be evident or erase details. I soak with Rubio Monocoat, then with an air nozzle in one hand to remove

Thanks for the info Bryce. ?I eventually found the manual taped to the top of the extractor and it detailed the seal placement as you described. For future reference: The sock filter part number is:

Ok, i just remembered to check for a part number for the wiping brushes, and came up empty handed i'm afraid. I would contact your local Felder rep, i'm sure they will be able to sort them out for

Fun removing the wax finish to do conversion varnish basically after sand it all often make sure every bit of the wax is gone otherwise it doesn’t work And yes, as far as I’m concerned, conversion

Hi Andrew, I'm definitely no authority on this subject, but having just pulled the filters out of my RL200 to manually clean them, i can tell you that the seals on it are level with the inside edge

Hi John, I use it all the time and with a bit of care, it will give perfect results. I'm helping Whitehill out in North America so feel free to reach out with any questions you may have.? I suggest

Thank you Henrik,Daniel & Michael! I will definitely include hard wax oil and tung oil in my tests. Mariusz

I bought mine for large tenon work and I can’t fault it. Set the fence up as a bump stop and the tenon shoulders work out perfect. Kindest Regards Jonathan Samways www.fineinteriorwoodwork.com

I really like mine. 4” may require something done with guards. Mark Foster

Thank you Andy

I have. And they work as advertised. I find they are fit ready off the shaper and only occasionally need to refine them with a hand plane. I thought at first the head being on top of the spindle would

Has anyone here used the Whitehill Hammer / felder flush mount combi heads for long tenons? ?I have a felder F700z . ?I build reproduction furniture so i was thinking this head could be used to