开云体育

Dang Bryce! How did they manage to scare that up?! Wade

Ouch martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/ Designing and building

I think indoor drone (with obstacle sensing) will be very usefull when it comes to shop video. I use Osmo and iphone with tripod.

Yes you should ?. Just kidding Bryce. I believe most who have participated in this thread have Felder tilt bracket. At least I did not read otherwise. I shared my experience to add information. Is

iPhone 11 on tripod. Shop lights. Regards from Perth Derek

Ah gotcha. Thanks Imran, i must have missed that. Clearly i need to read more carefully! :) -- https://www.brycecomerwoodworks.com/ https://www.youtube.com/channel/UCHdrRaAZd_pOa7wwbdNPUEw

After just 3 days with a new employee, and about 4 hours after me going through everything on the CF741 (& actually bringing up the point that the slider is aluminum and to be careful) this happened.

I really should read these posts more carefully. I didn't realize it was a homemade job on the gas strut. Regards, Bryce -- https://www.brycecomerwoodworks.com/

Tim Ruth, I didn’t anticipate the woodchuck (as I remember them as) Bees ? eating the lumber outside but covered on racks, I was more concerned about termites and vermin. Those bees are scary

Bryce, For this reason, I asked Laurie about speeding up or brake disengaging. He confirmed that it actually speeds up. So my first shot in the dark is that K1 contacts are sticking. Imran Malik

Bob, I use Four cameras: * Sony Alpha 6100 - was the main, now shared with the next camera (with a Rode wireless lavalier system) * DJI Osmo Pocket 3 * Apple iPhone 16 pro max * GoPro Hero 11 - no

Bryce, My experience with homemade gas strut is similar. I have vario4 which is pretty heavy. I don’t have video of lifting but I can start the lift with one finger. I do have a video of taking it

Great question Bob! I would like to know that too! Chris Rozycki

Hi Bryce, The Felder F48 feeder is a beast in terms of mass. Plus it has the old style collar and dual knuckle that is used to rotate it from horizontal to vertical work. if it was relegated to being

Bryce are you using the Felder stand with the comatic? [email protected]> wrote:

Ok, so here is a pic of the brake board. It should allow some adjustment, see picture, should be P1-Time to stop ?P2-Torque to stop faster. It is a fine balance, the board can wear out over time

Sounds like the brake board might need some adjustment. I will look for some documentation and get back to you. There are two pots to adjust, and it only takes the slightest tweek to make a

Reading through the comments on this thread, its really interesting to hear that some people are still finding lifting the feeder a bit of a chore even with the gas strut assisted bracket. I just got

Maybe slightly off topic, but wondering if the members would be willing to share what gear they use to shoot shop videos? Especially if you self-shoot without an assistant. Are you using a phone?

As you get older flipping the feeder up is more of a chore. I use a nylon strap around the feeder and a small chain hoist to raise or lower it, no risk of an injury to myself or the feeder. Regards,