开云体育

Lucky- That was excellent. Thank you for taking the time to write such a detailed explanation, I understand significantly more now. I notice that you discuss the length of the work, but not the width.

Ok, i'll try to add something to this topic. It depends...... What are you trying to rip? How many? What thickness? There are so many questions that need answering before an answer can be given. Here

Thanks David, I have roughly 40 feet of 8" ducting along with around 30 feet of 6" and 30 feet of 5" so far. The sheet metal isn't hot, however i can certainly feel warm air around the machine when i

Thanks David, Yep, it's running in the correct direction. It's just starting to cool off here in Canada, & maybe i'm just sensitive to the temperature difference?? :) I am going to check the amperage

Ahem, I rip on the right side of the blade all the time on my Kappa 400. Yes, we consistently get a better finish (cleaner cut, more consistent, straight) when using the sliding table and a mixture of

Have you confirmed that the impeller is rotating in the correct direction? It will suck sawdust even if running backward but will put out a lot more heat. My RL-160 does emit heat, and will drive up

Hi Bryce: Thanks for your post. With regard to the heat, I wonder whether you have been running it without ducting, or without much ducting while you sort out the niggles? If so, the RL machines (and

Major or minor? All in the eyes of the beholder. It was a major pain in the ass to fix, especially with no guidance or assistance from the manufacturer. Just sayin’ Chris Rozycki

Chris, I am sure you can make just as good a product as Felder on your Hammer. Just have to deal with some minor annoyances ? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Thanks Imran! I guess that’s what I get for buying a $15,000 hobby horse instead of a real horse ?! My bad! Chris Rozycki

Bill Belanger of fog may be able to help! Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Paul on the side of the pond are use air handling contact is Kae martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@...

Both of my saws, KF700 and K975, come with transitions. A round hose fits round ports on each end. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hi all, I just picked up a used RL200 and have a few questions. I have it up and running & been working through some little niggles over the past couple of days. Firstly, the filters were pretty

How hard would it be to design and make a rectangular-to-round, metal, flexible adapter for the Felder/ Hammer saws that would simplify the transition and replacement? And why don’t these really

Thank you Davide

I purchased a 5” spiral hose from woodcraft which was the least flexible but super heavy duty. This is what I use on the saw and since the blade swings to 45, it is very helpful that it is flexible

I have been using 120mm hose from WholesaleHoses.com in my DIY/hobby use for about 5 years. They have stood up pretty well.?? - Rich M.

Hey Paul, I recently purchased 4" dust hose from woodcraft that was surprisingly flexible. You may check their offerings to see what's available. Jarrett [email protected]> wrote:

Just a word of warning. I had a long length of Felder hose on my CF731. After it failed I bought a similar spec locally but it was too inflexible. So I ordered a replacement from Felder and it turned