开云体育

Aaron, I have always said NO to the air shipment charge from Europe and opted for the 4-6 week delay. Which means that the parts come on the scheduled monthly shipment. I also make sure that the quote

In my experience, if you don't do the $70 DHL option, any small parts orders may or may not ever get to you. -Aaron

SW, Things that come directly from Austria have the 'DHL' shipping charge of $70 min I was told yesterday.? If you opt for the 8-12 week version, you get UPS ground rates from Delaware.? They must

Hi Shinta, If it is the LCD screen and the segments are garbled or there is contamination within then you have to replace the LCD. The display can be in DIP (dual in line package) package, which is

There used to be a plastic film that protect the LCD plastic from scratch when the saw first shipped.? I removed that after the saw was commissioned a long time ago.? I don't remember if there was

I assume LCD display is fine and the haze is on the clear plastic cover. Can you tell if it is on the inside or the outside? If inside, I would try to disassemble and see if it can be cleaned. I

Take the plastic off? martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/

Is there a protective film sitting over the display. Wade

Hello everyone.? I have an interesting problem.? Two of the digital flip stop LCDs have developed this haziness.? I am not sure when it started because I haven't used the saw for a while.? Only

Sean, Your instincts serve you well.? On a 240volt single phase machine with a three wire original plug, Green/Yellow is ground and the others are interchangeable. PK

Im in the process of hardwiring my AD741 (it was previously wired to a plug) and im not sure which wire is which? I know the yellow/green is ground, and from my understanding, in 220, the other two

Smart answer Bill!! Same for me!! Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

For what it’s worth, I had that little fence on my K915 and I don’t have it on my Kappa 400 and I don’t miss it a bit. I’ve never said “I wish I had that fence”. With Macs clamps and

The only accurate reference surfaces on the X-Roll sliding table are the two chamfered surfaces on the top of the P-channel. Otherwise, the sliding table is an aluminum extrusion made by squirting

Thanks David Davies. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

You need to drill and tap some holes in the cast iron surface. Dave Davies [email protected]> wrote:

Thanks Tom. I went to the link but it is not clear how this table is attached to the main table. Do you know? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Thanks Nate. But if one can avoid this it is preferred. More concerning would be when one forgets and ends up ruining a workpiece that has already much milling time in it. Imran Malik

Hi Imran, Due to the short cross cut squaring issues already covered earlier, I configured my Profil 45Z with an outrigger, since the outrigger is easily squared and is very repeatable. That being

Imran, I saw a video from David Lucky that uses a dial indicator to square the fence. It looks relatively easy to dial the fence.