开云体育

Hello everyone.? I have an interesting problem.? Two of the digital flip stop LCDs have developed this haziness.? I am not sure when it started because I haven't used the saw for a while.? Only

Sean, Your instincts serve you well.? On a 240volt single phase machine with a three wire original plug, Green/Yellow is ground and the others are interchangeable. PK

Im in the process of hardwiring my AD741 (it was previously wired to a plug) and im not sure which wire is which? I know the yellow/green is ground, and from my understanding, in 220, the other two

Smart answer Bill!! Same for me!! Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

For what it’s worth, I had that little fence on my K915 and I don’t have it on my Kappa 400 and I don’t miss it a bit. I’ve never said “I wish I had that fence”. With Macs clamps and

The only accurate reference surfaces on the X-Roll sliding table are the two chamfered surfaces on the top of the P-channel. Otherwise, the sliding table is an aluminum extrusion made by squirting

Thanks David Davies. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

You need to drill and tap some holes in the cast iron surface. Dave Davies [email protected]> wrote:

Thanks Tom. I went to the link but it is not clear how this table is attached to the main table. Do you know? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Thanks Nate. But if one can avoid this it is preferred. More concerning would be when one forgets and ends up ruining a workpiece that has already much milling time in it. Imran Malik

Hi Imran, Due to the short cross cut squaring issues already covered earlier, I configured my Profil 45Z with an outrigger, since the outrigger is easily squared and is very repeatable. That being

Imran, I saw a video from David Lucky that uses a dial indicator to square the fence. It looks relatively easy to dial the fence.

In light of this discussion, what people do on shapers with XRoll? This is something, I may pickup in future. I have been looking for one with outrigger but that does not seem to be common. Also

David, those links are very informative, thanks.? As someone who doesn't currently own a Felder slider, but is just thinking of buying one, looking at what you had to do fills me with a certain

About 8 years ago, my shop got significantly smaller, when I shoehorned in my CNC mill into a spot where it barely fit. Specifically, it made it very difficult to use the long crosscut fence: I really

Chris, The reason I stopped making the short crosscut fence upgrade kits is because of the tight tolerances required for the kit to actually correct for the Felder design flaw and all the back and

Another one interesting in getting two

I’m in Ed

Thanks David, beautiful work. My short crosscut fence is always going on and off my k700 and i’m tired of having to fine tune it for square each time. I also notice that the fence gets pulled

Thank you David.