开云体育

Ron, The following is my conclusion after a similar experience. My c3-31 was delivered in 2017. The scoring unit (not a separate motor) was used for several months building cabinets for the shop,

When I was searching for a torque wrench to change the inserts on my cutter heads I was looking for something like this. https://www.biketiresdirect.com/product/lezyne-torque-drive-tool?fltr= Its

The only thing I can say is make sure you use proper lubricant and damn good clamps. Make sure use -0 to negative rake on your carbide saw blade. Mac,, martin/campshure/co/llc mac campshure 7412

No problem cutting aluminum, will not harm the machine at all other than possibly the dust collection hoses. Hot aluminum chips will most likely melt the hoses, been there, done that. I've cut a lot

If it is a new belt, you might be dealing with it stretching and then once loose it throws the belt. Best to check alignment of the pulleys as well. Is this machine using a separate motor to drive the

The normal saws have the option "73 Spraying unit to assist in processing light metals or plastics", so I think the saw itself is fine for cutting light aluminum.? However, this option is not on the

I haven’t seen this mentioned elsewhere on the forum, but possible I’ve missed… On a couple of occasions I have trashed my scoring blade drive belt by not having the blade set low enough to

I applied with Felder and now have 2 tickets. Thanks Gabriella.

Am I mad ripping thin aluminium extrusions on my new kf700sp? (Machine coming next week) It's only about 1.6mm thick and I use to do 100's of metres on my old $1000 cabinet saw and didn't think twice

Steve, Bummer, I was hoping to see you there. PK

Hi Henry, The BF6 electricals (shared earlier) are very similar to my KF700 from 2002 with the exception of brake board that eliminated P1, K5 & K6. AFAIK, this basic circuit continues today with the

Hi Imran, It's close but with a few notable differences, some that could be the product of half-baked repairs and others that are inherent design differences on the board. For example: the fuses on

Hi Henry, Does this look like your machine? I am sure you already know. KS is start relay. K1 keeps machine powered. K5 & K6 are for braking. HTH, Imran

Thank you Imran - I did email Felder a few weeks ago and they provided this same system diagram. Unfortunately the schematic is similar but not identical to how my machine is built (the wire numbers

Henry, You look familiar with the electrical components and wiring. I will email you BF631 manual that has electrical wirings of various single and 3 phase models. I assume it is comprehensive so you

I've got a single phase '99 BF6 which has been giving me some trouble lately. I bought the machine used and a pervious owner (now deceased) had made a few modifications inside the electrical cabinet,

Nice table! Very well executed! Brian Lambblamb11@...

Jason, This video shows how I edge seam veneers using the Sawboy.? The first half of the video shows several uses of the jig. https://www.youtube.com/watch?v=dRQCWQLoJmA Steve

I don't know the shape and size of your work piece so can't be specific or opine on what tool is a far better choice.? Generally, a sine plate or bar is a work holding device.? A protractor

For anyone else in this position, this nut was the issue. Tightening it straightened out the face that the aluminum extrusion sits against.