开云体育

This has been discussed at length several times before. Have a look at the discussion in this thread from the archives: /g/felderownersgroup/topic/96689739#msg128173 Here’s another

Paul, I’ve been there, done that. You are lucky that Felder had spare parts for a 25 year old machine. Please review the attached document that describes the procedure I used to make bearing way

Anyone out there incorporate their router table/lift into their sliders outfeed extension table? I should be taking delivery of a new kappa 450x in a few weeks and selling my Sawstop. One issue I will

Hi Paul, I have only done this for Xroll and nothing (in regards to ways) is loosened in this process. If you have loosened the rail, that would be a bear to get right again. I recall David Best

Hi All, I’m replacing the slider bearings on my BF-741 saw/shaper. (While another person was operating it the bearing car migrated so far forward that the plastic housing snagged and snapped ? )

Tnx for the info Rgrds Bob

Thank you Tom for your feedback. it is a bit too late since I got the slider yesterday :) (I ordered Felders DRO

Hi Netanel, I ordered my KF700 without the DRO on the rip fence, but after running a few specialty projects that would have benefitted from the DRO, I reached out to Felder and was able to order the

Thanks PK. That is what I recall as well and shared the link for the same type to the OP. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Imran, These are the best feet, they don't "Spit" the rubber piece out... PK

In Canada it is about 1 inch per 10 feet, 2 inches per 20 feet and so on for garage floors. This will allow adequate drainage for example for snow melting off vehicles in winter. Elwin K

Now I’m confused. I’m not saying you are wrong, but unless Felder has modified their measuring tape system, the measurement scale should be movable - if for no other reason than to facilitate

The strip that move left to right is only on the rip fence. On the crosscut fence it is fixed and it doesn't move. This is why I think I'll have issues with the calibrate it. For the crosscut fence I

This is another "deja vu all over again" topic that is constantly brought up. There are plenty of suggestions in the message archive. It’s also discussed in my Survival Guide which you have. Here is

I unpacked the saw and found out that the factory ignored my request for metric scale and the crosscut fence arrived with with imperial units :angry-emoji: It looks like the scale is permanent

That’s 2” per meter, right? David Best - via mobile phone

Typical slope specced for the houses we've built in LA is 2" towards garage doors.

Gidday Associated with this, but not to do with levelling machinery, what is the slope put on such garage floors for drainage? Expressed as H/L My son has a problem on a new construct and he is

My K3 had leveling feet (or was it part of the mobility kit?) Anyway I just order some Mcmaster

I picked up my slider today from Felder warehouse in Sacramento and dropped of my old K3 slider. I rented a 12 ft trailer from United rentals. loading up the K3 was super easy with the mobility kit