开云体育

More than likely, you’ve left your wheel engaged when not using the planer. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

My planner is not engaging / slipping at higher speed setting.? ? I noticed this after maybe setting my depth of cut a little too deep on a wide board (my mistake). I took off the back panel and

Here is my experience and viewpoint. I purchased a Dylos DC1100 Pro Air Quality Monitor a few years ago when I was troubleshooting a fireplace that wasn’t drawing well. I did some research including

I have a Laguna version of that device. I cannot find n English-language version of that site to be sure, but it looks very similar. I rarely use it, as my dust collection works pretty well and I use

I’ve owned a Jet AFS-1000B filter that looks just like that for 8 years…works well for cleaning the air but is loud, and very heavy when you try to mount it to the ceiling. Jet has redesigned the

Hey all, I am struggling to get my A3-41 jointer tables to correctly joint a board without any concavity. I've got the tables coplanar (points of contact at the throat and ends, they aren't flat

Hi there, definitely won't be running 3 phase. Looking at Laguna c flux 3, Clearview (looks too tall), Sherwood

Also, wondering how often you need to change? a fine dust bag vs the course bag shavings? Running buzzer/thicknesser, saw, bandsaw. Chris.

Hello Everyone, Are you aware of this device? https://www.felder-group.com/de-ch/shop/luftfilter-sc449842/number-1-luftfilter-lf-950-sp449841 There seem to be a similar offering in the similar price

I think you are expected to get the machine in position and connected to power and dust extraction before the tech shows up. The tech and I worked together to install the slider on my saw. I had the

My machine just arrived West sacramento and it is ready for pickup. I paid Felder to commission my saw and I wonder if any of you have a list of things I should check before I release the guy? Should

Without going down a dark rabbit hole and getting into deep discussion about this stuff it all depends on the impeller size and motor speed. Any advice from the US can't apply to Australia because our

On Mon, Apr 22, 2024 at 01:33 PM, Mike wrote: What dust collector do you have? I would only ever have one gate open at a time - not sure how to handle the top saw duct collection. Haven't received the

Thanks.. will have a look now!

Hi all, I'm new to the group here and also new to owning Felder equipment as I recently bought a 2001 made?4Kw 3p?AD741 (green paint) along with a 15hp rotary phase converter. The machine has a hand

I installed radiant floor heating when I poured the 2400SF concrete floor over 2 inches of foam insulation. That was only three years ago when propane was under $2 per gallon. Now it is $3.59 per

For heating my 900 square foot garage/shop, I went with a radiant tube heater. One tube heats the entire garage. I don’t have to worry about dust and since the radiant heater heats objects and not

For my money, Hydronic heating is the way to go, if you can do it! It’s quiet and out of site for the most part! Wade

PK: Thank you for the mini split / dust collection comments. Not my intent to hijack this thread, if the main topic is different… Recently, I expanded my shop from 400sq’ to 800 sq’, and

Here in our 4000 square foot shop in Minneapolis, we have 2 Reznor hanging shop heaters. They are gas fired, forced air units. Don't go this route. We have regular issues with these heaters. We have