开云体育

Hi Andrew, Not sure why, but the schematic is still not readable. You mention fuse beside each other as in physical location and I am assuming that these are the 2 fuses on each leg of the primary in

Thankyou for the suggestions David, the 24V system has an intentional bridge to ground from the bus bar, I have continuity running through entire system to ground. The fuses I replaced them with were

My apologies, the upload must have ruined the resolution. May come out better if I upload right from my phone, let’s see:

Love my ellis drill press. It fell over while i was fork lifting it by myseld and landed on the vfd. A few hits with a hammer to straighten things out and it still works perfectly. Not something i

Hi Andrew, Can you please attach a higher resolution pic for schematic. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

I’ll offer a couple of ideas. First would be to test the 24V circuit to see if it’s been shorted to ground by a crimped wire somewhere in the micro-switch chain. A continuity tester of

Hello All, first time post here, looking for some help. I recently acquired a 2008 Felder AD951 Combination Jointer/Planer. After getting it hooked up it worked fantastic for about 2 months... then

Thanks David. I’m looking forward to seeing the Ellis DP in person next week. I don’t foresee using it for milling so I’m leaning toward the belt driven. Not that it’s a concern, but the Ellis

I keep meaning to go fire up my Solberga SE2025 drill press because I don't ever remember being bothered by the sound level of it but I just had a bone spur removed on my foot so I'm not doing much of

Yes Tom, I have used the Ellis 9500 DP. Great belt-driven machine and a really great company to deal with. if you don’t mind the noise of a gearhead machine, the Solberga is perhaps better choice -

John:Sage Advice… Mike D. Sent from Yahoo Mail for iPad

If you injure yourself or a helper, you will wish you had spent the $500. -- John Hinman Boise ID K700S and A941

To continue the discussion on drill presses, I have found a company that sells the Ellis 9500 drill press somewhat close to me. I'm going next week to look at it first hand. The Ellis 9500 is a little

Thank you, it may prove helpful. Alan

Hey Mac, That looks real handy! Wade

Just so long as you know, there's no guaranteed machine that can be bought, due to the non-adjustability of the motor, on any saw being made today. BTDT with the far Eastern new route, and all the

I’ve been considering a widebelt sander for quite some time. Unfortunately I have severe access constraints given my shop is in the basement. This has basically limited me to very small widebelts or

Matt, I hope that I am not stating something you already know as I may have misinterpreted part of your post. This is regarding the availability of the S400P and MM16 models from SCM/Minimax in the

Thanks for all your replies. Your input is appreciated. If i'm honest at this point I'm not really looking for a massive saw - workshop restrictions mean that a degree of mobility is a requirement.

Thanks for all the suggestions! I really needed some names and brands to research and I have a bunch now. Thanks again everyone! Chris