开云体育

Did powermatic not sell there? I've been on the same hunt in the US and ended up finding a 70s era powermatic 1200 3phase. For woodworking I'll overdrive it. ?Get BlueMail for Android ?

HI Chris: Where are you located? I’m in Brisbane. Ahh yes, Hare and Forbes and their proverbial green machines from our Asian neighbours. I’ve had plenty of those too. At $1000 AUD you’re

I ended up buying a Freeborn insert set. Was actually $100 cheaper than the Byrd! Any chance you can tell what is the power feeder bolt pattern on the f700?

On 16 Mar 2024 02:30, Colum <colum@...> wrote: Big issue for me as I make a lot of parallel cuts to make box sides and drawers and its fustrating. As a tangential solution: Did you

Hi, have recently purchased a CF 741 combination machine and am struggling to align the fence as it has the longer fence for the Jointer. Have purchased a smaller length fence that fits the

Derek: I'll second your comments, regarding the N4400. I've had mine for approximately 5 years, and consider it good value for the money paid.? I've put a lot of hard mileage on it. That said, I

Willis also sells Alzmetal, German I have a medium size unit. Nice drill press not quite to my brown and sharpes quality. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

Matt, I have had my N4400 for about 15 years. I cannot comment how it compares with much else as my previous bandsaw was a generic Taiwanese 14", and really forgetable. The N4400 has been utterly

I really like the looks of that Solberga. It might meet my standards. Rong Fu used to make a clone of the Solberga geared-head DP, but sadly discontinued it.

The same problem exists on my 2016 FB510 bandsaw, very poor design for a bandsaw at this price range. I paid C$3955 (3500 plus tax) in 2016 after getting a C$500 show discount. Today, the list price

Here is a link illustrating the issue - make sure you can deal with this before you buy. It’s a systemic problem with this N4400 machine, and makes veneer resewing a huge

Best drill press made today in USA: https://ellissaw.com/drill-press-9400/ David

What’s the market look like in AUS for old iron? Most 40’s-70’s vintage machines would satisfy your needs. I’ve owned Rockwell, Buffalo, and Walker Turner and been happy with all if available

Lucky, One more data point for you: my Hammer machine (mid-2021) also uses the same system as that shown by John on his Felder unit. Regards, Jacques

Hi Caesar - ? ? I got my Voyager in 2017, I was not even aware that it had a brake. I've had the Llambrich for about three years.? I have not noticed the chuck loosening, but I will pay closer

Happy with my Bosch 710

Hey Rich, I changed out to Nova's keyless chuck. I've been happy with it but on occasion it will loosen itself when the brake is applied. Does the Llambrich do the same? It's very seldom and the only

Good. Just wanted to be sure you are aware and not get surprised afterwards even though you tried to research ? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hi Imran Thanks for reply. Yes I am aware that the N4400 is not without some flaws. I got the impression this particular issue wasn't universal and the 'fudged' solution is to to not over-tighten the

Waemsey, (not sure if this is your name), No one has mentioned it in this thread but I thought people had issues with N4400. Have you searched it here? One I recall is related to the upper bearing