开云体育

I know that Jaon Bents ( https://www.youtube.com/@bentswoodworking ) was at Felder recently to shot a calibration video for the Hammer K3/A3

Hi Tom, Thanks! That actually is helpful. Apparently I was trying to adjust the height by adjusting both sides of the outfeed bed instead of just getting it level front to back, and THEN adjusting the

I am confused by the air slot feature.? The work piece being cut has effectively zero clearance and air flow is limited by the kerf in the piece and by the tooth gullet carrying waste.? Saw teeth

Hi Ryan, Congrats on the new-to-you machine. I haven't needed to tune my A3-41, but I did see that Felder has a series of YouTube videos showing how to adjust their Hammer jointer/planer combo

Hi everyone, I got a used Hammer A3 31 Jointer/planer combination machine. It was in great condition but the infeed and outfeed beds got out of alignment in transit and now I can't seem to get them

Me too please (k975) thanks

Another interested

Hi David, Brian, your feedback is very valuable. I understand the use cases of the longer xcut fence. I think my usage will be the same as Brian, and a story stick with a fixed length together with

Hi Brian: Ha! So easy. You are absolutely right and assuming he does not need it all the time, you just answered Netanel’s question. Thanks for sharing Brian. Warm regards, Lucky From:

Same. Especially because this happened today ??♂? Steve

Bob, that sounds like a good option - router table function "added" with no additional floor space used. I, too, find that a useful addition and have stopped using my high- speed shaper spindle. I

I have a nice extension table attached to my k700s. I have the perfect place to drop a router lift into it. It's melamine/mdf top. I have a shaper but am finding I have a need for a router table from

Hi David, I see your point for long parts with multiple features like you describe. I will say however, that given the extension on my rip fence gets extended once or twice a year if that, that it

Hi Netanel: You’ve received some excellent responses so far. I think they are all valid and I especially like the suggestion that you need to weigh up the pros and cons of the option. Like the

And another configuration change. I decided to splurge on the K2 power drive

My take: the ability to make repeatable cuts without the need to make spare parts. I sometimes moving back and forth from configurations, so it is nice to be able to repeat it. The measurement line on

I like DRO on Xcut. You get exact repeat, at least as long as you don’t remove the xcut fence or change blade. For trimming, if I can measure the diff with caliper, it is one and done. The criticism

I also remain interested.

Having the digital extension is crucial in our use regularly,KF700SP, doing a lot of entry-door and large table trim/cut work. Most of the need is just enough to pull out the extension in the first

Thanks for your input