开云体育

Response from Ridge Carbide on drilling pins holes in the CMT Dado Pro Set: Normally, we don’t have any issue modifying other manufacturer’s blades. But this set already has a “bunch” of holes

Looks like it would be about $275US for the set shipped to USA. Sure would be nice to have a metric set of dados and shims to fit a Felder. I’m awaiting a response from Ridge Carbide to see if they

Pierre, Your connections look good to me. If you do not have a 110 outlet near by that is not a bad idea. Before running air thru the shop I used a baby air compressor for clamps. Extra outlets never

Thank you all for the precious info. I will simply install another electrical box using the same circuit as my machine on the floor to plug in the feeder. Now I need to figure out which wire goes

For overhead dust collection boom arms or any boom arm where you want the most flexibility of positioning, that means an articulating boom arm. ?For articulating boom arms used for dust collection,

I was planning to buy a K700 with just a few options when I was alerted by Imran on this group to a used machine in Texas. I had to make a fast decision, which was hard on such a large purchase, but I

Thanks!

Larry, if you are planning on doing a shop build of something similar to the medical light in Brians ?post, try going onto YouTube and searching for "overhead dust collection boom arm". these involve

Hi Michael, Per your private msg, please see the installation pics. BTW, I picked up the power after the master switch. There are provisions in my KF700 electrical cabinet that allow the wiring to go

I managed to clean it eventually - compressed air helped a lot - in case it's useful to someone else, with the saw lowered remove the saw blade and clean as much as you can using tissues and a long

Thanks for the excellent points, Brian. I am probably in the 9' x 10', 10' x 10' range but it depends on where I end up putting it. I have a space inside of my existing building that would be ideal

When considering shipping it getting expensive. Ridge sell dado set and for $409 (you can usually find coupons of 15% that lowers it to ~$350).

Thanks John. I completely represent the comment "whatever size you choose you will fill it up." Regardless of the size house, garage, or shop my wife and I have ever owned, we have filled it up. We

Ok I can weigh in here. I just built a new shop, roughly the same size as yours, and I had to include an office in it. Originally i was thinking the same as you. I know my real passion is in the shop

I installed an electrical outlet in the chassis of my KF700. Mounted inside the chassis the outlet sits flush with the outer surface of the chassis. Let me know if you would like a picture. Imran

The lower doors have a full sheet of MDO on outside and inside faces. Upper doors use a single sheet outside and inside face. I had to reskin left side lower door in 2016 because of neglect. In place

Hook up to machine power they draw squat. recently set up a feeder to my Gomad shaper. Used machine power. I have a light start stop button so I can run by itself, but if I have to hit stop for shaper

Mine is wired into the same feed as the saw. Brian Lamb blamb11@... www.lambtoolworks.com

I spent 40 years in offices about 10’ x 10’. That provides room for a desk, file cabinet, layout table, bookshelves, and space for a visitor to sit. Used to keep a drafting table with parallel

I finally received the tilting device for my power feeder last week. I had to grind a bit of the metal to allow one of the sides to fit into rail on the machine (I am surprised how poorly milled one