开云体育

I would also be interested in several for my k700 if you feel up to making some. John Adank jnadank@...

I have nothing good to say about the Felder clamp, except that I no longer have it. I use Milescraft and Kreg clamps. The Milescraft with the base kit fits a KF700 without modification. I use it as a

I would also like an insert for my K700S, please add me to your list. Thanks, Chris

DAN, i WOULD ALSO LIKE TO PURCHASE SOME ZERO INSERTS FOR MY K700S. Please add me to your customer list when you start building them again. Best Regards, *Scott Glaser* *6627 Dolan Falls* *Flower

Jonathan, Thanks for the picture. It looks like I'll need to grind off a couple threads off the hold-down bolt and it will fit. My solution won't be quite as elegant as yours - I tend to use what's

I haven't replaced with anything else bigger yet, though it does use a lot of air, it's easy to flip open a valve by the saw when I notice a performance drop cleaning up at end of the day. It comes

Does the GT13 shaker work well, Brett?

Hi William, Thanks for the link. The Bridge City version looks pretty nice...think I'll jump on YouTube and see if I can find any videos. Larry

Installed this before the official accessory existed....Amazon buy,pneumatic vibratory mechanism GT13. I consider it necessary equipment, esp. if you overload your cyclone ever or you don't have a

Since there seem to be more than a few Clearvue owners on the list.... any of you have the shaker? Does it work well? -Bob

Dan, I’m also interested in zero clearance inserts. Please let me know if you have any for sale. Thanks!!! Happy Day!!! Randall Sent from my iPad Pro (12.9 inch)

Hi Larry, Bridge City Tools sells a less expensive version. I have not tried this but it is very similar to the design of the Harvey version and only

Correct, the bands have a North Pole arrangement in the banding that repeats every 5mm, so cutting it would make it almost impossible to get a continuous correct reading across two pieces. Brian

You can cut the mag strip, but you can't join in. I found out the hard way, needed extra length on the rip side and joined it, the reader loses a couple of mm even with a tight joint. Kindest

Yes, cuts with tin snips. Brian Lamb blamb11@... www.lambtoolworks.com

Wanted to verify that you can trim the magnetic strip to length?

Resending rip fence install pictures. They didn't seem to work the first time.

Hi Glenn, not at the present time but I am going to make a batch at some point in the beginning of the new year. I will make an update on here when that happens.

Hi Andy, Im also in the northeast, Massachusetts to be specific. I bought an f700z with digital height last fall. It’s not for sale but if you were close enough and wanted to come by my shop to see

Hi All, Happy Holidays I’m wishing you all the best in the new year. I’m interested in picking up a second higher spec shaper to supplement my combo machine. Ideally a lightly used f700z or