开云体育

Ed, When I got the rangate I copied the top that Joe Calhoon made for his at the Alpine shop.? I used 5/4 Maple. No holes in the top.? I have another workbench with a parf top that I made. The

As an FYI, when I was thinking about the Rangate cart before I went with the Husky, Greg at Rangate (this was in August, 2022) told me they can make a top in any size I want and can even have the 22mm

Ed, lack of power sounds like a loose belt. Regards from Perth Derek

Thanks everyone. I ended up ordering the Rangate cart with 4 locking casters. I assume it will be here sometime next week. I’ll share photos once I get a top built.

Yep — they are pretty great although I’d like another two locks. It’s only an issue when on a very unlevel portion of my garage floor.

habacomike, Did you keep the original wheels? Wade

Thanks Brian. ?I'll try that. For some reason, the group emails were bouncing but now I seem to have fixed it... Mike

I was one of the early buyers of the Rangate 300 cart. ?I built a table for it and couldn't be happier. ?Well, I could if it was half as much...

On Mon, Jul 10, 2023 at 7:33 PM Wade Dees <wjdsignature@...> wrote: > Wouldn’t even consider anything from Husky, but that Barth 300XL & Felder > Fat 300S look really nice, especially

Have you checked toe in/out? Do you get burning on one side or the other of the blade on the cut stock? Brian Lamb blamb11@... www.lambtoolworks.com

Dave for specific tasks these are .025 range and expensive . Catch variation in bore so easy to make mate. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

“so I think it got my mind obsessing…” We call that the FOG effect mk

Hello to all Felder owners, It's been quite a while since I posted. I have owned my single phase K700 for a bit more than a year now and am not satisfied with the way the saw is cutting. I bought

Not cheap either. Dave ________________________________ Sent: Tuesday, July 11, 2023 9:46 AM To: [email protected] <[email protected]> Subject: Re: [FOG] Advice on dial indicator

Very limited, the size range gets smaller the smaller the hole size is, but not uncommon for range to be between .100" and .400” from smallest to largest. You need a lot of Tri-mic’s to cover the

What size ranges ? I have the two prong bore indicators but have wanted the three but stocking so many sizes slowed me down. Dave ________________________________ Sent: Tuesday, July 11, 2023 9:32 AM

Dave another way, quite handy for specific tasks. Three point carbide anvils. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

Here's another vote for the Husky tables. I use mine for an assembly/outfeed table for my bandsaw. I have the original casters on mine at the moment. My floor is smooth enough, so it hasn't been an

Okay, thanks everyone. I'll just leave this adjustment alone. I spent virtually the whole weekend getting the infeed table coplanar with the outfeed table and got every measurement point within

Yes. It’s similar in scope, but I don’t recommend it for something like 0.005” difference across the thicknessed material. The adjustment is accomplished by altering the planer table height on