开云体育

Having yet to actually mount the Felder dado set and make some cuts, I figured this would be a good way to do some tests and see for myself the "bat ears". Each dado measures 7mm H x 12mm W I cut some

Hi, I find the following for the 125mm rebate head 1) it fits below the table 2) the radius is small enough to match most furniture requirements 3) there are many bearing type guide rings at, and

If I have a choice I always adjust the non hinge side For the A3 you put a 0.15mm feeler gauge under the straight edge at the far end of the hinge side of the outfeed table the raise the infeed table

This is sold....

Hi, new unused D951 for sale still have the original pallet and foot mount cleats for shipping asking $14,000 firm on that for the moment.? Machine is three phase 7.5hp spiral cutter head still under

I would Criss cross strap to the tunnel under the tables. Hold down the machine with the felder clips and box base to deck with 2x4’s Lock tables down take . cover with plastic and stretch wrap

This has been discussed and debated several times over the years here on FOG. Have a look at the following threads in the archive:

Hello and thank you in advance for any input. I am a proud new owner of a 2012 AD741, not the new body style but the one that the base steps down in width. I have gathered I think on this forum that

I agree with Lucky, the bat ears are visible but I don’t design furniture with exposed dados. Also they serve to make exceptionally clean cuts.

Glad you got it working! Brian Lamb blamb11@... www.lambtoolworks.com

Hi Murray: Very kind of you to say that. I do not find the bat ears to be a negativity and therefore have not tried to “hone them down”. They are big enough to see, for sure, and in fine furniture

Well, I reexamined my work and found several faults. First, Mac was right. The infeed table was clamped much too tight. Second, I determined that the bolts on the hinge were too loose, causing the

They are a beautiful detail that u can see with a magnifying glass. Allows you to cut in x and y that’s the beauty. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

I’m just wondering if there is any consensus on the significance of the “bat ears“ issue? Lucky, you do fine work, do you find this to be a problem? Has anyone honed ?the nickers, if so, how do

Hi guys Just my two cents. I am fortunate to have a very large shop with cathedral high ceilings and mezzanines for storage. During the planning stages I knew that I needed some lifting equipment to

Had old timer hefty Herman for 20 plus years. Very handy for construction an in shop work this one was great but to big For in shop would m love one of those Skyjack the very small one !! By used they

Good morning, With this group, I figured someone has experience with these heavy equipment. Skylar, thank you for your offer.? I haven't looked at anything in person.? I found a used Genie 1930 on

We have 18' ceilings in our 40x100 shop. Would have a scissor lift if we could afford the floor space to park it in addition to our forklift. We had a big overhead project last year removing a bus bar

I tell everyone that owns a scissor or an electric boom, the batteries are the single most important part of the machine. If you don’t take care of them, you will run into many problems in the

I was not interested in the saw, I got the jointer. I took some pics of the saw however when I was there, if anyone is interested. It is older and has phenolic bearing races on the slider.? Tom Ruth