开云体育

Not sure about your K700 but my CF731 router spindle rotates at a higher speed than the standard shaper spindle. The higer speeds are better for router bits -- Paul Mc Cann

I also follow the roblandX31 group (also on groups.io) since I have a Robland machine. This forum, while Felder-oriented, has been a huge source of knowledge for me - electrical issues, setup issues,

On May 21, 2023 13:01, "Rich M." <rmarkiewicz@...> wrote: My C3 manuals only show this one circuit schematic drawing (PDF attached). It is item 7 Bremsplatine (brake PCB). I am fairly certain

Thanks David B. Your documentation (accessed from your Flickr link) is far more thorough than mine! Thanks for sharing. Warm regards, Lucky From: [email protected]

On May 22, 2023 04:00, Larry Long Neck <longneckwood@...> wrote: I'm curious how many folks directly use email to respond to threads rather than the UI? Usually only through e-mail, although

I thought I would chime in with some photos of a KF700 shaper hood with 220mm diameter tooling installed for comparison. I pulled these photos out of the archive and they relate to the KF700 and F700.

Hi Jacques: No worries. I was replying to Steve’s original query about the 228mm dado and feasibility of using it in a shaper. Apologies if I mixed up my reply with your post about the tenoning

David, Thanks for the info. Your pictures describe well the possibilities and limitations associated with large cutter heads. Maybe my earlier message was not clear; I made reference to the use of the

Hi Steve: I think you’re asking the right questions on your quest to educate yourself and make purchase decision that suit you. The published capacities sometimes do not equate to the real world.

I only use email to respond to topics. Sometimes I visit the site if I am posting a new topic. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Steven, My 2002 KF700 hood is 240mm and the table opening is advertised to be 9” but it might be slightly bigger. Largest tooling I have used is 220mm w/o issue. Imran Malik

This is the first groups.io/email group I've joined. I'm curious how many folks directly use email to respond to threads rather than the UI? And if there is anything else that makes this format more

Dave, Minimax owners on groupsIO Mark Foster

Steven, Others with more experience will pitch in with more detailed info, but here is a bit of what I have experienced. With the tenoning hood (and plate associated) I can run a 250mm (actually a 10

Thank you, Imran. The reason I ask is because I own the Felder dado set, and I'm in the market for a shaper. It's helpful if I can limit the amount of tooling costs up front until I figure out my work

Matt, These stickers refer to the shipping bolts which lock the trunnion in place during shipping. You'll need to remove these so you can use the arbor tilt. Do not attempt to tilt the arbor without

Where is the minimax forum? Dave Davies

4K for a good condition Moak is a very good price. Dave ________________________________ Sent: Saturday, May 20, 2023 11:18 PM To: [email protected] <[email protected]> Subject:

This is the main forum I visit. ?I have been on sawmill creek and find it useful for info on hand tools and some general woodworking topics (and have seen posts by some of the FOG "regulars" there).

sawmillcreek.. woodworkforums.com, minimax, occasionally I hop on woodweb.