开云体育

Another idea is to move the bed 20mm when you shut down. Then hit reset after you power up if it doesn't say 20mm.

Whitehill tools is great as well and a little more economical. https://www.whitehill-tools.com

Yeah. I should have gone with them in the first place. From Infinity i got the rail/style kit. the deep tennon kit. and the raise panel stuff for $3,000. Which is about half as much as the same stuff

Rangate Dave Davies

I ordered about $3,000 worth of cutter heads and knives from Infinity Tools to help with a door project I have. I placed the order back on January 10th. They still have not sent the completed order to

I’m on the hunt for a new in box or lightly used Laguna Driftmaster fence for re-sawing veneer. Please let me know if anyone has one going under-loved or knows where one can be found. Thanks!

I built a 42” x 26” extension for my 25.5 jp About 6’ from outfeed roll, Very handy , putting extensions on jointer bar style for 20” felder extensions and longer one with leg some day.

I purchased those machines, and sold my TP-300 within 24 hours of placing it up for sale. ?I have known the dealer you are referring to for many years. ?It is not often that these become available

When you get into Martin type quality of planer design, Tersa vs Spiral is more about dust collection than finish quality. Tersa excels on a top end machine, Spiral compensates for design compromises.

Thanks for the input on the cutter block selection. Rough cost is +$4k per machine for spiral over Tersa which breaks the bank if I didn't already.? Joel if you bought your machines recently there

Plane a piece of hardwood down from 30mm to 20mm checking with calipers each time until it is exactly 20mm, leave the bed where it is and hold the reset button. It should reset to 20mm.

Bill: Sorry - I should have included in the first message ?! The height is essentially the same - 15.3mm. J.

Jacques, What is the overall height? Mine is 15mm. BB <jacques.gagnon309@...> wrote:

That absolutely helps Jacques! Thanks so much! Bill <jacques.gagnon309@...> wrote:

Thanks Brian. One step at a time into the worm can... :) BB [email protected]> wrote:

Bill, I just made a profile (using red oak) to insert in the slider of my B3. The measurements for the piece I will use on my machine are: 21.8mm for the bottom width (32 on your drawing) 9.6mm for

Hi Bill, As for how many configurations, a lot of different ones. I just finished printing some nuts for a bridge clamp I built for my machine, it’s an old F-channel slider. Compared to yours,

I made some T nuts for the Felder slider. Unfortunately, I only have the Kappa 400 table to measure, and someone who purchased some for his B3 Hammer said they were too wide. So can someone tell me

Recently, I was able to purchase a 1-year old local t45-54. ?I sold my JP and other personal belongings to generate $ and free up space. ?I would say that getting used local was what allowed it to

I likely have a different generation of A3 combo unit that you, but did experience a similar problem with the locking handle on mine. My solution was to simply not leave the locking handle tightened