开云体育

Made by Italian company ACM, rebadged Felder, just like Felder's X40 series bandsaw. https://www.acmitaly.it/en/summa-740-2-p8

So individual based on space followed by money with everything based on what you do. I also sold my Unisaw when I purchased a slider. ?If I had unlimited space and money, I would have kept it for

If you keep tools around that you are familiar with using, you will always end up finding an excuse to use them...In which case why did you upgrade?? I only have the slider, no cabinet saw. Keeping

That’s a transmission error between your digital stop and the unit that calculates the distance offset when the fence is angled. Could be a weak battery, or some interference on the bluetooth

Sorry to ask this again, I asked about 3 years ago and now I don't remember and can't find the answer. What is this display telling me and how to I fix it? I've checked batteries... Thanks in advance.

The Felder FB 740 with sliding table in the auction was purchased by a local lumber reseller. The machine has a 240V 3ph motor, though the auction listed it as 400V. I've seen photos online of a

I am no machinery expert, but I do know that Langzauner Edge Sanders and Zimmermann OSS and perhaps other European machines are only available in 400v and one can get an outdoor 400V transformer

The only one of those to come to the USA was sold at auction in January for just under $6,000. See this thread. /g/felderownersgroup/topic/96252390#127738 That machine is not made by

Felder introduced a bandsaw with a sliding table FB740S. It's one of those things that I never thought about, but was obvious the moment I saw it. Fortunately, it's so big and expensive that I won't

There are three sliders in the shop, but there's still room for the sawstop. It is still used for dados, and ripping of solid woods. If you have space, I'd let it stay. I'd also invest in or make some

Horacio, Since you are a mechanical engineer, you might appreciate the technical analysis of just what the induced angle would be if you have your sliding table set to the proper height relative to

I was going to say this. Keep a track saw handy. Less space and less expensive.

I must say that the support this group provides is immense. A little about myself since I forgot to add this before. My name is Horacio Nochetto and i am a mechanical engineer by trade. i always loved

Jonathan, Like Imran said, generally higher rating is fine.? Typically these are a maximum value if you read the spec sheet. Lower rating is not good, unless you like sparks and exploding capacitors.

When I bought a K700S slider I had intended to sell my 5HP Powermatic cabinet saw - but I hesitated and found that the cabinet saw was super useful for ripping AND for dados. There seems to be no

I got rid of my cabinet saw almost as soon as I got the Hammer C3 combo. I've never used the rip fence as you would on a cabinet saw (in fact I barely use it at all). On the rare occasions that I do

I am in very nearly the same boat. I sold my Unisaw when I bought my slider almost a year go. I’m still struggling with ripping. What was a simple, intuitive, and accurate process has become a much

Good morning (H?), Having switched to a slider about 18 months ago my experience is not as extensive as other members here. Nevertheless I have not experienced problems with the angled cut you

Another school day. Kindest regards Jonathan Samways fineinteriorwoodwork.com richardmartinwindows.com

Jonathan, A higher voltage rating is fine as long as the capacitor size is acceptable. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share