开云体育

This will be my first time attending the IWF show in Atlanta.? I have attended most IWFS shows (Las Vegas) in the last decade or more because it is relatively close but never attended IWF (I was told

Roger, It was a test.? It did work and useful to turn your table saw in to a rip saw - they are great to process a ton of similar parts quickly.? Gang rip saws have been using this idea for decades

Metro Detroit Kind regards, Brian D. Milidrag *New Century Realtors* 200 E. Big Beaver Rd.| Troy, MI | 48084 Cell 248.7 <(248)%20283-8118>65.8411 | f 248.680.0 <(248)%20644-8226>062

Where are you located? -- John Hinman Boise ID K700S and A941

This is a maple workbench. I can't imagine it would be economical to ship but if interested droop me a line. asking $750 but willing to negotiate.

Hello all, I’m moving/shrinking my shop, as a result of our building being sold/gentrified, we are all being evicted. I’m keeping my felder combo machine and selling the large/full size KX7 panel

Hi Brad, slider length s 2800mm which is 110". 1500MM outrigger (45.25" x25.25") and 1100mm (43") rear crosscut fence.

My woodworking club is selling a Robland Combo machine and a Champ/Fond Shaper with extensive cutters for attractive prices.? Both items were donated by an estate. They are located in a home shop in

Seven years in with my A3-31 silent head. I word with very hard and abrasive West Australian timbers. Just on the third rotation. Probably could have gone another year on the second. Two big

I’m intrigued to see you using (I assume so from the orientation in the photo) it on the table saw. When I bought my feeder for the C3-31 combi, I thought that I’d spec it enough to cover all

Many thanks to all and the very good advice. The comment regarding them lasting a long time is spot on and I wish I’d realised this before rotating mine as my machine has had even less use ! Getting

Hello Neil, I’m ?a new member of the group. I sent you a private message but I’m not sure if it was sent. I’m based in the UK and just setting up a new shop so I am interested. The CF731 is

On my old Table saw - crude test.? We learned later that the mag strips need to be parallel to the arm (or we need larger magnets). PK

The following files and folders have been uploaded to the Files area of the [email protected] group. * /Electrical/Implementing VFD in a Multi-Motor Machine.pdf (

Tom, Thanks for sharing valuable advice. I would not have known this. Steve

Both of these are sold. Thanks Jack

I don’t own a Felder jointer/planer, but I follow a similar process to Tom. The first time I did it on my 20” Byrd head, I felt like I got sold a bag of goods. Every bit of marketing material

Hi Roger! The first question I would ask is: "When you rotated your inserts, did you fully remove them and clean all of the resin and dust off the tooling head and back side of the inserts?" Most of

Jay, what is the slider length on this saw? Brad

So I got my torque wrench. Removed, rotated, refitted, tightened. Haven’t used it much but today planing a wide board and I notice that I’ve got some inserts slightly badly fitted…I faffed