开云体育

Ah, okay. Thanks Bill

Just the rod/measuring device. I use the platform to support plywood. Bill Bélanger

Bill, Can’t remember if this was a completely parallel fence or just the stop rod? Thx, Wade

Message sent! -- John Hinman Boise ID K700S, and expecting an A941 in April 2022

To the guys that expressed interest in ordering an insert (Ed, Mike, Jared, Wade, John), they are done! I routed a slot in each piece for the riving knife. One thing to keep in mind when installing

1290 long

Hi Bill, How long the the extrusion with scale and can you share a pic of the bracket by the reticle? I would like to figure out how I can attach it to an ext table and use it. Imran

Mike has decided his base is too short for the readout so if anyone else needs it make me an offer. Bill Belanger

That’s how I do it also. Mark Foster

The only time the platen gets removed here is for hogging off with a 60 grit belt. There's a 100 or 120 grit belt on the machine 95% of the time. I haven't measured the thickness difference between

Thanks for that pointer, Jerry! Tim [email protected]> wrote:

Tim, To be sure of a parallel cut, I always set the front (fritz) to the measurement and then slide Franz up to Fritz and use a straight scrap piece to align Franz with Fritz.? ?I only really use

On Fri, Mar 11, 2022 at 12:36 PM, Wade Dees wrote: > > > You just click on their name in the above info, and it sets a new email > page, directed to them only. > > Wade > > >> On Mar 11, 2022, at 7:53

I ordered a zero clearance insert with my K700 that is coming in next month. Based on what I am hearing, I would also be interested in purchasing one of these inserts. My saw will not have a scoring

So how much moolah does one need to shell out for this engineering marvel?

Me too.

Nice work, Tim. If I'm reading your photos correctly, it looks you ripped the board and both ends are within 0.001". That's what I like to see. David

Unleaded I guess. Not sure. ? Warm regards, David Dr David Luckensmeyer ________________________________ Sent: Saturday, March 12, 2022 4:35:40 PM To: [email protected]

What does his jig run?

I'd also be interested in buying a couple of the wenge inserts!