开云体育

Thank you Wade, I have reached out to the seller, it appears they no longer have any store front or stock, but am awaiting a response. Thanks again for the lead. Anthony

Yes!? ?You need not read further than Sang's first reply (but if you did read more, you should the corrections to the other replies? ;-)

Compared to the Martin WWII tank factory, the Felder production facility is breathtakingly modern. But my guess is that Felder's engineering NIH attitudes would drive you bonkers. They have a proven

It's not a bad idea! I visited their factory in Tirol and it was *the best* grown up activity I've done in recent years. Super inspiring to see all their big machines and more interestingly how our

Maybe you should start working for Felder! Looks super cool.. PK

I'm jelly! Working on on a poor man's retrofit for my saw, with just a small set of functionality. We'll see how it goes!

Felder service typically calls before coming out to commission the machine and asks questions about the electrical service. Often they ask for voltage readings, etc. John, Sang Luu’s first reply to

How would the tech even know?? ?Is it not already connected to power?? And how?is it connected?? Did it come with a plug?? Did you attach a plug?? Are you hard-wiring into a junction box?

On Wed, Mar 2, 2022 at 10:43 AM, Mark Kessler wrote No.? A circuit breaker's only function is to protect the wires from the breaker to the device (here, a table saw.)? The circuit breaker has no

Mark, I went back and read the post and your right I didn't answer the question. If that was a dedicated 20A circuit he could most likely get away with using it. I would run a separate dedicated

I doubt your tech will care.? When it's all said and done, as has been noted: * the breaker protects the wiring * the saw will attempt to run on any wiring you give it, whether sized correctly or not

I did not mean to poke a hornet’s nest here! The discussion has been most interesting, though. The NEC is really complicated. My background is the AASHTO Bridge code and the structural portions of

Bill, at risk of being annoyingly repetitive, I would again note that you're not addressing the poster's question.? ?You are providing perfectly good advice for someone who is planning to install a

The NEC is of nearly Quranic complexity.? ?Almost nothing can be definitely demonstrated by quoting simple fragments.? Every other sentence in the NEC references other sections, footnotes, and

One other thing to dig the hole even deeper, and Mark T don’t go off the deep end ? as i am not claiming anything here but wouldn’t/couldn’t we want to know what the motor protection is as

I just received a call from Carl.? According to Felder at the Factory, my profil 45 will come with the new touch panel! Hopefully we are still on target for the time frame! PK

Bill, I guess I will stop here. I just don’t want people to read this thread and think they can wire connected resistive loads for the full amperage of the CB, which is implied here. Imran

Imran I think Mark is coming at this technically and you are starting to get into the weeds with the code stuff, nothing wrong with that, but in this case figuring out what size breaker and wire gauge

If interested, a free online copy of the NEC is available here. You will need to register and select the free option vs the enhanced version offered by this outfit.

Mark, I was concerned about that, as I alluded to you in my DM . Care to share the relevant code? Imran