开云体育

Jason what brand? I am looking at VSM cloth right now because I can buy a min of 2 Butt it’s a butt joint (pun intended) The zirc is only $5 more per belt But here is the other thing these

Mark, For your volume of use in a one man shop, I don't think that would pay off. We are using Aluminum Oxide, with 5 people in the shop and belts last months. Here's a photo of the diagonal wiggly

Wade, 5/16" - 18 thread. [image: IMG_1932.JPG] [image: IMG_1931.JPG] James

These pictures are spot on that L bracket and holes for the overarm do not line up at all at least in this picture the holes are partially visible. I am a good 3/8" off I'd say, not a big deal just

Mark, I was initially encouraged to use strictly paper backed belts by my Uneeda distributor. In the 7 years since acquiring (Safety Speed 4375), Here's what's evolved: Resawn surfaces aside, I am

Seams on mine are on a diagonal but sine wave sounds fancy. I assume they included the principal frequency and all of it’s harmonics in the seam design so it must be harmonically balanced; clever

Jason, so what brand are you using, I thought you mentioned it but can’t find it. When you said straight seam, you mean a butt joint? VSM just told me that was the way to go Regards, Mark

I will also agree about the problem with the Kreg automaxx clamp.? I have found if you hold on firmly to whatever it is you're clamping as you activate the clamp, you can over power the lateral pull

Thank You James, Just curious, do you happen to know what the thread size Kreg uses on that underside clamp screw they provide? Wade

Lloyd, My resaw setup must be better than yours as 120 is takes out saw marks in a pass or two? We can even glue directly off the bandsaw. I was having bad chatter marks off the sander for a while,

Wade, What Bill posted is a special nut that is designed to be secured at couple of locations (designed for that nut) in the slider slot to mount the short xcut fence. One does not need that for jigs

typo, 1/4" - 20 thread. James [email protected]> wrote:

Wade, Yes, 6" automaxx can reach over the fence. It is 1/14" - 20 thread. No, I did not make the t-nut, I do not have the milling machine. It was made by a machine shop. James

Bill, With your set up, can you lock the Kreg clamp to the slider bed, prior to clapping down your material. I was wondering if they make a Kipp lever that would match the threads that are machined in

Another question, does it make sense to go to a Zirconium belt for the 80 and 100? Regards, Mark https://www.instagram.com/kessler_woodworks/

Hey James, Thank you for sending this. So you can reach over the crosscut cut fence with the 6” version clamp without having to modify it? What thread sizes did you use? Did you machine the t-nuts

Wade, Yes, I have 2 different length custom made t-nut, the short one's dimension is the same as the t-nut with the Felder clamp. [image: IMG_1928.JPG] [image: IMG_1927.JPG][image:

John, The overhead guard is heavy and awkward as hell. I did it myself with blocking but you must be very careful not to knock it over and not get in a hurry. Two people with some blocking should be

John, The ripping shoe came with my saw. I didn’t order it. I do have a set of mac’s clamps on order and can’t wait to get them on the saw! Steve

I tried that automax once before I made my air clamps, went back in the drawer it came out of… Regards, Mark https://www.instagram.com/kessler_woodworks/