开云体育

Thank you, Mark! -- John Hinman Boise ID Not a Felder Owner yet - expecting K700S in February and A941 in April 2022

Mark, I am confused, fairly normal for me. You don’t show the business end with the stop block. Are you saying, the side with stop block is same as the one we can see? This (opposite to the stop

John, sorry I have been away from my computer but here you go. Mine are made of 2 layers of 18mm BB with a sacrificial piece walnut piece of walnut glue don the end then cut to fit. This helps me

Sweet looking feather board!

? okay…that works too! ??

?? Yep, got it. Thx

Thank you David. Definitely going to try and locate the sensor inside the cabinet, closer to the motor. Thx, Wade

Bet no where close to what I paid for the Aigner setup ?

Glen, Watch this video from 6:30 in the timeline through 8:15. The last part of that section really shows off the one of the chief advantages. https://youtu.be/BTQbKkJWQ5M

All I can tell you is that it works reliably in triggering my Ecogate Greenbox 12 controller. I do remember adjusting the sensitivity. The router is a PC 7519. David Best

Super nice!! [email protected]> wrote:

David B. Actually maybe I need a lesson on how to use it. I made one when I got my saw and I never use it. As you know I have DRO cross cut fence and Mac's clamps and just use that. I do use the

David, if you clamped the CT around the entire router cord your total current should be zero (amps in (hot) - amps out (neutral)). I'm confused as to how that could possibly work reliably without

I was wondering why I have never seen this Kreg stop. Looking at it carefully, I see you cut the long stop leg :) [image: stop.jpg] James

You should check out what Mark Kessler did - posted today on Instagram. David Best https://www.flickr.com/photos/davidpbest/collections/ https://www.instagram.com/davidpbest/

No need for two. I got over creative a few years back. I only use one. Thanks, Chris Perren

Very nice setup Chris! Trying to figure why two sets of stops? Bill Bélanger

Below are Kreg stops on my simple F&F jig. Thanks, Chris Perren

I was interested in something for my bandsaw and not permanently mounted. Anxious to see it. Bill B

I’m confused by "I measure off the rip head as a bump stop” and "the stops create a gap between the two faces preventing smaller pieces being gripped between the two faces” Sounds to me like you