开云体育

Yes, lots of prior discussions but on one of those it was mentioned the Highland Woodworking "Wood Slicer" and I have been using both 3/4" and 1/2" with satisfactory results for a non-carbide blade.

Mark It was pointed out to me a few months ago that there’s a lot of historic discussion on this topic. Easy to search. But the summary (for me) is Lenox Tri-Master, 1”, 2-3 tooth. Not cheap but

Can you drill an appropriately sized hole in a hefty block of wood, then cut the block in half through the center of the hole, and use that to clamp the spindle in a stout vice to hold it? Cheers

Would some of you who do a lot of resawing please mention your choice of blade? Mark

Brian, Agreed.? Impact would be where I would start.? I have had amazing luck with what seemed the most seized fasteners. PK

Turn it 90? in the vise so the slots dig into the wood jaws. That might hold it rotationally well enough to get it loose. Also, it might toast your socket, but an impact wrench would be much more

Well, I am having no luck in holding the router spindle in vice to remove the spanner nut. I am not much of a gearhead so ideas are welcome. Below is a summary of what I have tried with no luck. Oh! I

Bandsaw Power Feeder- I love having one on the machine, hate taking it off. In my opinion, a bandsaw power feeder necessitates having multiple bandsaws to regain versatility. I also don't think that a

I would look at DMS out of Colorado, they make the Patriot machines (Who SCMI is now peddling as well). All ball screw, extremely stout. If’n I had the money, that is the one I’d be looking at.

https://www.woodworkforums.com/f200/hammer-k3-improving-dust-collectionmm-230872

I don't have one and someone with one will likely respond but I don't understand how the single wheel $1,600 feeder

Thanks. I’ve only seen single level versions. What are your thoughts about using the power feeder on the shaper? wrote:

Fred, Here's a picture of the setup. The Aigner bits can be purchased from Martin, Simantech, or SCOSARG ( in the UK) Dave Davies [image: image.png]

Dave, I have the same machine and have thought about adding a power feeder as well. 1) what are the Aigner pressure modules you mentioned and how are they attached? 2) I wonder if positioning my

I had a Laguna 16 HD for 20 years and it was great. Recently had the chance to upgrade to a Felder 610. No difference in quality, just size (imo). Brian@...> wrote:

I have an SCM 24" bandsaw and haven't had any complaints. I keep thinking I need to get a powerfeeder for it but manage using Aigner pressure modules. Dave Davies Brian@...>

Good morning, I’ve had my heart set on an Italian laguna for a while now, in the 18” resaw master range. Should I be considering equal sized felder or other machines? Thanks, Brian

I think it would reduce the cut depth further to the multi router if the PantoRouter dust shroud was installed on the multi router. James wrote:

I wonder why they didn't develop something on the other side of the router like the Pantorouter dust shroud? [image: image.png] Dave Davies -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

I have a Shopsabre PRO 4x8. I can't say enough about process and the machine itself. I use it mostly for furniture parts, templates, and some signage and carving of logos, etc. in desktops, tabletops,