开云体育

?Like Brian I also have never heard of Felder supplying leveling feet. I assume the holes you are speaking of on the right side (facing machine standing on the rip side) are located in the main

Mine did not come with feet Here are the ones i bought, i did have to enlarge the hole https://www.mcmaster.com/#2531K128 And I believe I bought these oversized thick Washers

No feet supplied that I have ever heard of. Brian Lamb blamb11@... www.lambtoolworks.com

Hi, I’m new to the group. I just received my Felder K940S sliding table saw. I called Felder before it arrived and they told me it comes with leveling feet. I’ve just finished unloading it and

I'm with Mark on not giving Uline my money. We use brown craft paper for these types of protective uses. We get it at Litin Paper on Plymouth Ave. It's totally adequate for the purpose, it's recycled

I'll second Imran's suggestion of confirming that the motor is wired correctly. I just received a new 3ph RL160, and the instructions are very insistent on confirming that the motor is spinning the

?I should add that you can try cleaning the filter as well. There is the differential pressure switch that indicates filter needs cleaning. It is however not reliable, as many folks state that the

Looks nice!! Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Friday, December 31, 2021 4:25:48 PM To: [email protected] <[email protected]>

Too fancy? ??? Bill [email protected]> wrote:

For those without a 3D printer, it was extremely easy to make my own from scap wood. Made wooden piece to fit inside the extrusion and attached a piece of Baltic birch plywood to it with two screws.

Bill, You have another taker here! PK PKwoodworking

18” freezer paper from Target, shiny side up taped down with blue tape. You’ll need to splice a couple of pieces together with a strip of blue tape to cover the whole surface and prevent leaks

I will lay paper for? glue ups. I buy those 36" wide rolls? of brown craft paper from the BORG.? often I can get multiple uses from? some of it. I have tried a heavy wax coating. It works but I

Jay, Is it a 3 phase motor? If so and if it has never run differently swap two of the 3 wires to change direction. This happened to me when I wired RL125. It pulled deceptively enough air that I did

Actually it is prepped for dado. Attached is the exact saw specs. The first one I sent was wrong version.

The saw/shaper is in a storage unit in Gypsum CO. I want 15k for it. It's not dado ready. 98" slider and single phase.

following...

Hi, I have an older RL160 I bought from a forum member this past summer that is like new condition. Unfortunately I am running into issues with the RL160 shutting off after about five minutes of use

Thanks Michael. Ordered the finish carpentry book from eBay. Didn’t see the DVDs anywhere, other than ordering from eBay which would amount to well over 100$ by the time shipping and import tax is

Thanks guys, this is all great info. Mark, no rush from my end, but yes I'd be interested to hear which version of wax paper you're using. Brett, good feedback and much appreciated. I agree that in