开云体育

Thanks so much David. Nice stuff! What I was looking for was an STL file that I could print in nylon. Bill Bélanger <david@...> wrote:

https://www.flickr.com/gp/davidpbest/ZoC3b6 David Best - via mobile phone

In looking at the 3D files, I find a DRO version of a fence attachment. I'm trying to redesign it to fit my Kappa 400 fence, but maybe someone else has already done this? The post is on the wrong side

You don’t have to use the cover strip, but it does protect the soft magnetic layer. I would use it. Brian Lamb blamb11@... www.lambtoolworks.com

Stupid question about the magnetic strip, The product comes with two strips, one thick that is supposed to the magnetic strip and one thin that is supposed to be a cover strip for protection. I guess

Massive, yes. I feel sorry for the hinges ;-) Cheers Eric

Thanks Tim. Will share when done. Wife excepts it finished by May. Will see, I have my doubts. Imran On Dec 30, 2021, at 12:52 PM, Tim House <casabueno@...> wrote:

Nice project! Those "square cuts" certainly assist on the glue up and joint fit. Please post a photo of the completed door(s). Tim House [email protected]> wrote:

Joinery detail

?Well massive for my hobby shop anyways. Two of my long flattest surfaces in the shop (10’ slider and 9.5’ jointer w/ext tables) in use for glueup of first door panel - 148” x 72”. Just used

Thanks David, I’ll revisit the leveling and the toe-out, and I understand that the slider is otherwise about as good as it is going to get. Cheers, Roger

Nevin, When this happened on my Hammer, the tech instructed me to tilt the blade to 45 degrees to facilitate access, and to lower the scoring unit to the lowest position. It was pretty easy from

Not sure on the KF but on the k700s that i use to have you have to crawl into the cabinet Regards, Mark https://www.instagram.com/kessler_woodworks/

Good day. I'm a semi-retired physician in Victoria, Tx with a KF 700 I purchased new in 2015. My problem is finding the way to replace the drive belt for my scoring blade. I recently found it in the

Hi all, Any preference to truing up the main roller? I haven't done it before,? but one option was full width abrasive glued to MDF.? The other is to place a narrower strip on a diagonal.? ?Third

Hi Roger, I looked at your video on Instagram. Here are my comments/suggestions: For best results, your machine should be on adjustable leveling feet instead of using shims under the base. The

JP, Is there an airbnb for workshops? If not, there should be one. A week in your shop sounds really good. Imran

All, As best I can match it under 3 different light sources RAL 6016 Turquoise Green with about a 30 % matt finish. Hopefully this will prove useful to others. Regards Paul

Roger, welcome to the group. I am not the guy to give advice on adjustments but David Best definitely is as well as Brian Lamb, Imran and many others here. As to the shim method I would buy adjusting

Roger, Is there another way for you to share video? Don’t do instagram and can’t login with facebook because acc to them I do not know my username. Imran On Dec 29, 2021, at 6:06 AM, Roger Martini