开云体育

Nobody has an insight? Seems like a common problem...

?Thanks to Michael Marsico, received ProLock shaper spindle locking caps today. FWIW, there is an icon on top to indicate that the allen set/grub screw is the one to tighten. I did not know how this

Thanks to Michael Marsico, received ProLock shaper spindle locking caps today. FWIW, there is an icon on top to indicate that the allen set/grub screw is the one to tighten. I did not know how this

when I am xcutting relatively narrow stock I move my outrigger to approximately middle of slider. This gives me good access to K975 switch panel. Imran

Complete plans for a wired remote are located in t he group files section. /g/felderownersgroup/files/FOG%20made%20products/remoteinstall.PDF David Best - Sent from my iPad

My add on switches are nearly as pretty but I got some coiled cord from McMaster and mounted a box that could be mounted anywhere on the slider like a butt bar. The original switches on the Knapp

See photo for oem with mac's plumbing. [email protected]> wrote:

Brandon, A high end (expensive) solution is based upon Schneider Harmony. There is a post on that as well. The poster did a pendent because multiple switches won’t fit in slider. IIRC, if you want

Brandon, My machine is 2019 kf700sp - the back round plastic handle at the end of the slider is packed with the buttons and 2 wires go through slider, a hole in the chassis, and a couple terminals on

Brandon, Check this post /g/felderownersgroup/message/114241 If interested, I can send you the details I shared with Stan Blaszczyk. Imran

It shouldn't be to hard. The start button should be wired parallel the stop button in serie with the others. The switches and the required gateway are quite expansive. I believe there recently was a

Is there any way to determine what options are available to retrofit a machine with the remote slider buttons? Mine has the belt driven scoring blade so I only need one start button. Stop probably

Thanks Marty. I guess, I am wondering if I have a code as well. Will figure out thru felder. Imran

Marty, Glad that worked for you! Interesting that your dro just shows the number. I figured U 2.1 was a software version but perhaps it is an error code? I'll have to contact felder support and

My dro doesn't show any codes on power up.? It shows the same number on power up as it did on power down. Cheers, Marty

Hi Marty, Glad it worked for you. Do you recall what your display shows upon power up? Imran

Sorry it took me so long to respond.? I followed Ameer's directions because his display looked the same as mine.? Everything worked fine except the reset button doesn't always "reset".? It's a bit

Mike, Please share the wiring diagram. Without that here is a generic response. If your machine is single phase check the start caps. Make sure all safety limit switches are inactive. Either way, 1P

Here is a link to an Abilene, TX Craigslist with several large woodworking/metalworking machines including two large bandsaws. Other than posting this Craigslist link I have no knowledge about any of

ahh man! I was hoping to buy it for a dime.. thanks a lot!! LOL