开云体育

I cannot improve on David's reply -- so this is a diversion. If you enjoy walking and like fresh trout, consider the 7km walk NNW from Seefeld to the Forellenhof in Weidach. Great food and

Ben, I recommend you contact Ruan du Toit via email - President of Felder USA - he can set you up. R.duToit@... David Best https://www.flickr.com/photos/davidpbest/albums

Leave the saw on ,,,simple. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/

No problem, I just meant you aren’t the first to run into it. I did one on my machine days after I got it in 2001. Wish I had used a lighter coiled cord, but it’s still working 20 plus years

I used it as the ceiling of an overhang to my porch. Tongue and groove machined easily, and it took finish very well. It has been installed for four years through central PA winters and hot humid

Thanks Brian, this is very helpful. I apologize for rehashing an old subject. I will start with a search next time. -- *Kevin J. Wells*

Thanks Mark, you have confirmed for me that I am using the saw properly. I am rebuilding my shop (original was lost in a 2017 California wildfire) and am building cabinets. I, too, don't normally work

Thanks Imran, I see that I am using the machine correctly and that a modification is needed to move the switch to a more convenient location. -- *Kevin J. Wells*

Thanks Michael. It is hard to keep up with finish choices. This one seems to focus on oily woods but probably works even better on other woods. Thanks for sharing. Imran

Thanks Imran. I used Epifanes and followed the directions on the can. It flows out really well. I used a small roller for the final coat on the top to make sure I had even distribution. Michael

Hi Michael, Very nice. What finish did you use? Imran

I went ahead with the Red Grandis for the patio furniture and wanted to give some feedback for anyone interested in using it in the future. ?It is a pleasant wood to work with as it machines well and

https://machinerymax.com/Event/LotDetails/27445694/MARTIN-T26-SLIDING-TABLE-SHAPER-WITH-COMATIC-FEEDER Imran

Hello All, In past years I've read many times about fellows from our group here arranging factory tours of Felder plant. I will be in Austria and basically in Tyrol in Seefeld for a few days which is

Common problem, solved many years ago by adding a pendant with start/stop buttons in it.

This is pretty common on most sliders, you turn the saw on first then load then cut. This is the way I did it for many years in my business and when I worked for others it is only with my ne k940 that

There's only one Power On switch on the Hammer, and it is indeed located on the "wrong" side of the blade.? If you're cutting a large sheet of plywood, or anything else that gets in the way of you

Hi Kevin, I am not familiar with hammer but if interested, I am sure you can figure out something like I did. /g/felderownersgroup/message/114241 Imran

I just cut the first 4’ x 8’ sheet of plywood on my new Hammer K3, and was perplexed at the location of the on/off switch. With the plywood oriented with the 8’ length perpendicular to the saw

908 399 8133 speak to? David Fine He has one? in his inventory? I don't know how much of it is there? It? is under a lot of other stuff