开云体育

Imran, Where is the thread you posted about hanging this mantle? I'm very interested in mantle hanging techniques at the moment. thanks, Ameer

Mark, I couldn’t have done it by myself. My neighbor helped. Fortunately, I did remember to wear my back brace. Imran

I hope you ate your Wheaties before starting that. It’s a hernia maker. Mark

Well yesterday I worked on the mantle I mentioned earlier seeking hanging advice. It took some time because my neighbor had miss calculated and the log was not long enough for main section and a

Hey Brett, Do you have a good idea of how you will be using a bander? I've always glued and clamped hardwood strips, but last year I had a large frameless kitchen. I got a used hot air machine from a

Brett, Interesting you post this, I am down to buying my last machines. Edgebander and Wide belt. Like you I donut want to buy used as There are too many unknowns. I have looked at a lot of wide belts

For production work, I outsource edgebanding to a local high volume shop that produces Ikea-like closet solutions. Production edgebanding machines are very maintenance intensive, especially if run

Probably not what you’re looking for but (given my scale, one man shop and don’t do a lot of edgebanding) I went with a Festool Conturo (the trim router and the vacuum clamps). Does a great job

Hi Brett! As an initial response, I'll volunteer that I am currently performing precious little edge banding, so I'm an example of a (very!) low volume shop. For what little edge banding I do apply, I

Thanks, ?I have watched the blade at a woodworking show and it is amazing. I was going to buy until I read a knot could damage it. I have not talked to anyone that has hit a knot with it. As to the

I'm starting to put together a plan for edgebanders. I am a novice at any edgebander brand, model, method. At this point it's a strategic step that may happen sooner or later, but I want to start

Sautershop does ship to the USA.? Checkout allows you to enter a U.S. address.

I put the blade in the cart and went to check out as a guest at sautershop.com.? USA as a shipping destination country was a choice among all the countries listed in the drop down menu.? This is

They don’t list the USA, as a place to ship. It seems like a lot of companies out of the USA show a lower price. If anyone buys a blade from them her in the USA let me know. Thanks Doug

The blades are also available at a lower price at: https://www.sautershop.com/ake-supersilent-3-universal-ak-78213004330?c=12648 Even including shipping the price is significantly lower than buying

You also need the 2mm riving knife. So factor that into the cost.

> > Yes. Just general use. I am lazy and hate changing blades. I have cut > walnut, white oak, and epoxy with no issues.

I got the information back and I can sell the banding for the price I have been, which is $90 per meter. If you need some just let me know. I am getting low on inventory, but just ordered a new roll.

Phil, Have you taken a look at elevation drive mechanism under the table and feed roller drive in the back? I just cleaned and lubed both on a 10 yr old dual51. Everything looked fine but according to

The feed rollers on my 2006 AD951 are occasionally, but with increasing frequency, failing to turn when switched on but are revived when I turn off and then restore power to the machine. A much less