开云体育

Jim, thanks for the recommendation! I will certainly add the Bosch to the list. I have had been pleased with the Bosch tools in my shop and it is great to hear about your experience as an everyday saw

Hi Mark: My assumption is that if 90 and 45 degrees are good, the software ought to be accurate enough to get all the angles in between. Maybe I’m being naive? Your hard stop question is beyond me.

Anthony I would check out Bosch's latest offering. I have used two different generations of their jobsite saws, and it exceeded expectations as we do house trim and kitchen installation for Habitat.

Thanks guys, what about the other angles 11,2°; 22,5°; 33,7°? I know about checking the 0 and 90. They Also told me not to adjust the hard stops which makes no sense to me, the encoder motors we

I was able to reach Tannewitz by phone as the set of hardened steel blocks for the upper guide was $140 so I ordered them. A pair of regular steel blocks for the Carter was only $22 so I am going to

I made the simple mod to the hood. I may drill and tap additional holes to get the fence over even further. I have always hated routers and always had a shaper so my view is skewed ? Sent:

Greg, Check the connector too.

switching time and then the setup time on the shaper drives most people away from using it...

Greg, To me, in way of prioritizing the trouble shooting, I would work on the table saw motor cabling. To be precise, the part between selector switch and the disconnect where you isolated the

Hi Imran, First, thanks again for thinking about this crazy situation. Yes!? Same exact outcome:? Shaper motor attached to Table Saw selector terminals fails to start, and moving the selector off

Thanks David, Like you and Lucky described, I do the cut test to confirm calibration. I calibrate with precision 90 & 45 squares. I am just curious what my wixey angle gauge does. If memory serves me

Imran, For the 90° stop, I cross cut a 1x3 on edge with the blade fully up, flip the off-cut over, put the two pieces back together on the bench and check with a straight edge. Same method with a 1 x

Hi Greg, When you plugged shaper motor into table saw position, was the outcome identical to what happens with original wiring and selecting table saw? That is, you have to power cycle to restart?

I guess i will need to check my angle gauge now. I did not use it to calibrate 90 & 45 stops on the saw though. Imran

Hi Glen: Apologies for the delayed reply. My pleasure for whatever help I was able to give. I also have ongoing “issues” but overall my RL250 is served well. Over the last week it has not been

Hi Imran, Thanks for your thoughts.? I have disconnected what I presumed was the offending motor.? Made no difference.? I have checked resistance across all three fields of each 3 phase motor, 1-2,

Hi Brian, I have checked all start and stop buttons, for continuity across the switch, whether N/O or N/C. No problems but I will now triple check since it is a possibility. I am going to entirely

I’m with Lucky on this one. I have not found that the digital angle indicators produce very accurate results when used the set the angle stops on the saw trunion. David Best

I too have that little Dewalt. I can't find much fault with it either. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Hi Mark: When calibrating my Kappa, I tried the tilt box method and was surprised how inaccurate it was for me. Maybe the fact that the tilt box is not accurate enough, or maybe the fact that a saw