开云体育

There is a Martin T70 on woodweb https://www.woodweb.com/exchanges/machinery/posts/529135.html Dave Davies -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

Tenryu blades on Amazon are cheap and good...and disposable Dave Davies [email protected]> wrote: -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

Where are you located. John Kee turned me to Leitz, I am sure they have multiple locations but Grand Rapids was the nearish to me (I am in Indiana). There is another place highly recommended here on

I have saved several Felder Universal blades over the last few years with the intent to have them sharpened. ?I have never accomplished this task. ?What service are others using? ?If you so your

Hi Imran, Cleveland area but willing to travel.

A high end architectural veneer shop near me uses diluted TiteBond, not sure which number, applied with a paint roller.? The moisture cooks off amazingly fast - compared to 24 hours in torsion boxes

i know this isn't the advice you asked for but if going the CV route, consider the max and 7" mains with 5" or 6" drops. You are running some decent sized equipment and the performance will be much

Acharya, I can offer just a data point. My basic 5” spiral pipe (not clamp type) from Rockler is 24ga. I have no concerns that it will collapse under negative pressure and is plenty sturdy

Hi Tom, I do not. I don’t remember mixing it, am thinking unibond rings a bell Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

Mark, Do you remember what the glue of choice was for hot press work?

This has been for sale for a while. https://sfbay.craigslist.org/eby/tls/d/oakland-felder-940-sliding-table-saw-new/7259455957.html

I have CT and been very happy with it throughout my shop. Blast Gate has been great to work with. Thanks, Chris Perren

I'm following up on some research from a while back on dust collection ducting. A while back, one user here shared that"blastgateco.com has the very same ducting as Norfab at lease 35% less

thanks so much fellas ...i had overlooked? the cover plate in the back of the slide and lo and behold there was a battery there....popped a new one in and voila!!!?? thanks again!!!!!

Good to know, David. Imran

It seems like i never throw anything away but the bearings are likely small and cheap. The rotor, end bell, and fan blades might be worth saving and I don't know if the stator and windings can be

Opps ... sorry should have restated that.? I am located in Twin Falls Idaho in south central Idaho mid-way between Salt Lake City and Boise.

It took me nearly 20 yrs to learn that I can stop the saw with shaper stop button ??? Imran

You still have other stop switches, at least on the models I am familiar with, along with the emergency stop. Imran