开云体育

New to the group. I have a delivery of 4 new machines due in 4 weeks (KF700, FB510, RL160, and Hammer A3-41. I am just a hobbist and am new to both sliders and Felder but after much research chose to

cmluck, I assume your dust collector motor is 3 phase since you mention it is controlled by a 3 phase contactor. How is this contactor switched? 110AC or 220AC or some DC voltage? I can at least

I would add, many times trying to get everything lined up perfectly on a machine is not always necessary(within reason). The best test is if the machine cuts straight, flat, and evenly. If the jointer

Greetings to all, I recently purchased, from Felder, a ZIEHL STW1K S225636 Dust Collector Control Module along with a few of the ZIEHL STWA1 Coil Transformers to control my dust collector. This module

There is a Brake on the Hammer JP?

Hi Richard, Yes, I'm in the states. I don't have any spindles. [email protected]> wrote:

Paul, what bits would you round up for spare inventory? As this one sits it only has one shaper spindle, so that's something to look for. I believe it can also power a mortiser, but I imagine those

Thanks for all the advice everyone! Imran, the machine does still have all of it's fences for the saw and shaper. It also has the jointer-guard (euro stye). Comes with a share spindle and a single

It does not do it all the time but enough to really aggrivate. I am taking a typical light cut (.02" to .025"), planner table is clean ?and waxed, the feed is set to ?slow and it will begin to sound

I’d also appreciate an exploded diagram pdf, if possible. Thanks to all Mike

Thanks for the thread. I had a brain fart while swapping blades on my bf6 and accidentally somehow turned the set screws for the table. I’ve not gotten it back since. Not good enough.

In answer to my own question, yes! there are 2 pairs of bolts underneath. If you slacken off the cross bolts that go through the round pins, the bolts underneath become loose too. You can then wind

Marlowe, I guess you are in the States? Do you have a high speed shaper spindle? Cheers. Richard.

Bf6 owners. I bought Felders spares for that vintage machine. I have lots of belts some guards kip levers and even some motors. I will look for parts you're interested in but don't expect rapid

I bought a 1994 Bf6-31 about a year or two ago now. Two previous owners were hobbiest. Great condition. Runs great. Owner started at $7000. Three months later I was driving home with it for $3000.

Had another look today, I can slacken off the bolts (13) but I don't see what will actually move the hinge? Bolt 31 is the lock bolt for the slide to lock the table height. There are 3? bolts going

I have a small outrigger and swing arm no slider tube or bracket FS Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Yes Finicky at best 31 locks the adjustment I think, If I remember table also has some movement in relation to cutter head helps to fit closer. Swearing helps if no one is

Joe I think you’re agreeing with me ? Centrifugal switch - hold it in…like your FB 600 No centrifugal switch - like Felder single phase motors - ie like the Hammer C3-31 Roger

Roger, Felder still uses single phase motors that do not have centrifugal switches. Although on my FB 600 bandsaw even though there was a big sticker on it that said it was necessary to hold down