开云体育

I’m not sure if the fence and extra end drums are with the machine. The manual is so I’m hopeful. Sent: Wednesday, December 9, 2020 12:59 PM To: [email protected] Subject: Re: [FOG]

Tom, Beautiful doors. You did them properly. I cheated with 3-ply face lamination. Imran Sent: Wednesday, December 09, 2020 2:17 PM To: [email protected] Subject: Re: [FOG] door building

I think it would be nice to have an easily removal very smooth surface accessory table as an option when you want no friction when moving things by hand along the sanding surface with the fences

Brian, I've just started using Tenryu recently.? Have not had to sharpen one yet, but I'm wondering if anyone can get them as sharp as the factory?? The polish on the teeth is amazing.

A torsion box would be a good way to go for that size of door.? I think a lot of people use 3/8" to 1/2" MDO for paneIs over a foam core, then cover with decorative wood, or thick veneers. I recently

Thanks Jonathan.

You did not say what width you are looking for. I have a Amana 10" flat top that cuts nice grooves. RB1224-30 Carbide Tipped Euro Rip with Cooling Slots 12 Inch Dia x 24T FT, 18 Deg, 30mm Bore

The machine was loaded yesterday and is supposed to be delivered 12/11. I won’t know until I see it here, the risk/excitement of buying a machine at auction without previewing it. I assume the owner

I did so with a Tenryu blade with Ridge Carbide, use it a couple of times, the cut was awful to use it as a general blade or too cumbersome for grooves. So now it is catching dust somewhere. Your

This was just discussed at length 3 weeks ago, here is the topic /g/felderownersgroup/topic/78453275#111406 </g/felderownersgroup/topic/78453275#111406> …. Felder

Yes, but then I’ve never had a Forrest…. but the Tenryu is/are the only blades I’ll buy now. Brian Lamb blamb11@... www.lambtoolworks.com

Stan, Martin USA carries them. I know John Sincerbeax loves his diamond blade. They aren't cheap. Martin wants $936 for the blade and you also need a new $114 riving knife. Dave -- Dave & Marie Davies

My company builds dry kilns for sawmills.? Our standard design door runs on a rail overhead and hooks into place to seal heat in.? We occasionally get request for side hinge or barn door style

Does anyone know where to get the pcd diamond blade? I do not see it in the US website anymore.

Tenryu seems pretty inexpensive on Amazon... https://www.amazon.com/Tenryu-IW-30028CBD3-300mm-Saw-Blade/dp/B003O3J2V8 Many on this forum tout their quality.? I have always been a Forrest guy.? Are

yes barn door is a project that requires it and i did 10 & 12 ft shiplap siding for the same addition earlier this yr. past these i will likely keep this space for J/P until i use up my air dried

Imran, your message is above and beyond. You've given me so much to think about. With your upcoming build, you're planning on the I-beam for the jamb, right? You don't think something like an LVL

I suppose I should clarify my email yesterday as it elicited a few responses both here and privately, not that we need to continue hijacking this thread in further discussion: 1. Yes, if you are

12' is really long, do you have some examples for which you needed or would need 12' that you cannot split in two. I can see a quadruple barn door system, but you can always split your top plate in

Anthony Thanks for the tip. Mike’s video is what got me tuned into the torsion box idea. And his materials and level of finish are about what I need. Bird