开云体育

Dave summed it up well. Can be done, but might be easier and cheaper to go with a transformer. I have a 24" Powermatic widebelt on woodweb if you have interest in a plug and play machine. Marlowe

I've swapped 575v for 230 and there can be lots to replace. You need to be sure of the IEC frame size and then see if 7.5 230v motor can be had in that size and shaft length for a reasonable cost. If

You would need to make sure any control logic transformers are swapped, not hard. Typically there is a transformer to power the controls. That would need to be changed too, not hard or expensive. I

james, first, there is no telling what each of us get when ordering from china. assuming specified power means something, the 5mW red focusable laser i purchased for about what you paid is not very

Hi guys,I’m looking at a used Holytek 15” open ended?wide belt sander that is 10hp and??575 volts. By the time I get a transformer and possibly a larger phase converter I will have spent more

I bought this 660nm 5mW Industrial Focusable Laser Line Module/Locator Laser with PSU&Bracket (only $15) last year, and have not installed it. https://www.ebay.ca/itm/261278696170 James

I made this purchase myself as well..I'm looking at various ways to mount it to a platform off my ceiling so it hangs about 9 feet off finish floor, but about 5 feet off the sliding table so hopefully

@Mark, you can see that blade in action in this thread: /g/felderownersgroup/topic/stool_progress/77800964?p=,,,100,0,0,0::recentpostdate%2Fsticky,,,100,2,0,77800964 The stool I was

If you don't have a gauge the procedure in the link below works to check if the cutters are parallel to the outfeed table. Setting Jointer Knives (highlandwoodworking.com) (

Thanks @ahazi. I've been thinking of retrofitting one of my laser levels for this purpose, but never had the time. Didn't know I could buy a green laser unit like this. I ordered it directly. Was told

David, From what your originally described, I don’t think this is a coplanar issue. Although, it might turn out to be. If your board catches the lip of the outfeed table at one side of the machine

Awesome Dennis. always good to have a drawing ? imran

thanks David. that is exactly what i needed. imran

On Wed, Nov 25, 2020 at 06:11 PM, Shawn Kammerer wrote: > > Hi David, > I've had my 941 running nonstop for about 2 1/2 years and have put a lot > of material through it. I think it's time to turn the

Thanks Patrick Initially, I could not imagine I'd put through anywhere near 5000 board feet.? Then, I wondered what this means!? If I prepare a face and edge on a 10' board across the jointer say

I uploaded the Felder drawing to files/manuals and drawings/Felder tenoning plate.pdf Dennis

Details here Imran: https://flic.kr/p/2iWwojJ <https://flic.kr/p/2iWwojJ> This is identical to the Felder supplied screw: https://www.mcmaster.com/93070A213/ <https://www.mcmaster.com/93070A213/> I

I think I ground the knives in the Oliver ITCH head about 3 years ago. That's in a shop with 4 full time furniture makers. They still don't really need it, which is great since the grinding is a

I put a spiral head from Byrd on my JP.? I got it from Felder, Carl was? looking to let it go cheap? because they were no longer installing them? having developed their own? So I think I got it

thanks Mac. good to know. imran