开云体育

Yes, I would not DIY given Felder's fair gas sprint price, there is a trick to get it installed in 5 minutes, I posted before. Just search "gas sprint". James

Thanks James - seems reasonable price-wise. D.

I ordered my 2016 KF700sp with F48 and tilt away bracket without gas spring assistance. After lifting the heavy F48 a dozen times, I decided to get the gas sprint, night and day difference. Here below

Mark- Depending on which one it appears. One is 4, one is 5. Michael Tagge Built Custom Carpentry Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Monday, November 23,

Hi Michael, tooth width is 5 mm so suppose the main use would be for drawer bottoms Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

Thanks Imran - I'll look it up! David

David, see this message for DIY solution: /g/felderownersgroup/message/111297 alternatively, you can replace your tilt bracket with one supplied by felder with gas strut. just make

Michael - no, I havent - but sounds like I should get one. Where did you get it? David

David- Do you have the gas strut on the powerfeed lift? That is probably a #1 must have option IMO on combo shapers because the powerfeed is really heavy otherwise but it fairly easy to manage with

Wider blade with an exact 4mm vs 3.4mm. Seems like a super niche product to me. Went with a flat top tip blade but haven’t had the opportunity to use it yet, all my cuts have been managed by the

Oh I see... Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

Mark, on a side note, in my 30 yrs of designing an engine control module(ECM), many times it appeared that we could just have 3 or 4 products and serve our entire clientele but it never materialized.

Anyone have experience with the Felder slotting cutter? Looking to use it as a joinery blade for cutting tenons, bridle joints anywhere i might want a flat bottom cut. Is there an advantage to the

mark, i am pretty sure if is the same board with parameters that allow it to be used for saw or shaper. my question was whether a single board is used vs two separate ones for saw and shaper? i

Imran, I would doubt they make a separate board for the saw, saw/shaper or what we have, (we could be the exception though) where I work our temperature control products have different features

I have power drive in my KF700SP - and couldnt be happier. Used to work at a place with a non-power drive Felder saw - and the power drive is well worth the money. I use it daily and it really helps

David, my K975 has motorized blade elevation w/o DRO and i believe Mark K mentioned his K700 had the same. it may be, as you mentioned, that felder does not offer it on saw/shapers. that is good to

I have never seen a Felder saw/shaper with motorized blade elevation that did not have a DRO indicating blade height. Such an option is not listed in any of the Felder spec sheets I have access to.

Just a thought, If you screw a strap of steel to two roof trusses and have a magnetic mount you can move side to side and angle easily. Sent: Sunday, November 22, 2020 10:56 AM To: