开云体育

Alan, are you able to verify that the siemens relays are working or not. i do see them available via internet search on PN. imran

Thanks TJ Cornish. There is a safety interlock, but it appears to have broken a long time ago and the two wire from the interlock are joined to bypass. The former owner inked a note on the cover that

Jesse at Eagle Tools in L.A.

Are there safety interlocks on the machine? If not, any generic magnetic motor starter set for the appropriate motor current should be fine.

I have an old Inca Euro-260 bandsaw - very nice small complement to my larger Felder FB600 bandsaw - but unfortunately the on/off switch died. ?I tried to get parts from incamachines.com in France.

Joe, is there a threaded hole in the upper arm behind the wheel for an eyebolt? The PH weighs 1800 lbs and supposedly the C frame is thick and reinforced. Minimum height is listed at 6'9" so you must

The challenge I’m seeing is there is not places I can see to attach straps to. If I remove the top wheel and brake stuff I could lift from the top of the arm but I’m not sure that’s strong

I bought a HF gantry crane to lift my MM bandsaw off the pallet Dave Davies

I've not lifted mine but I'm assuming the top wheel itself is too high and not just the guard rail. The good news is a good condition PH probably has better resale value than a 36". They are much

Hi all, I am back from picking up the Tannewitz I bought on auction.? I'm disappointed that it was a PH 30" and not a 36" but that's a risk I took with the sketchy listing.? At $775 with only one

Hey David, I? do keep the the table well waxed with a similar product. Thanks for the input

So it turns out that the brake board was bad.? I ordered a new one from Klinger Born in Germany for about 118 Euros (including shipping).? I replaced the brake board, and everything started right up

Pretty sure I shot for a 4” wide bevel, but it’s been so many years ago I can’t remember for sure. I know I needed the whole 12” blade. Brian Lamb blamb11@... www.lambtoolworks.com

FWIW, i found this used on Ebay in April. the cutting length is 60mm. it will do a bevel similar to Brian’s table but not sure if it can do exactly what Brian did. imran

Randy and Mark, thanks for the feedback. i would do the clean and stick. just wanted to avoid the messy adhesive if possible. imran

Thank you, that’s actually an ancient project, think it was about 2002. I couldn’t bring myself to sell or throw the table out when we sold that house and moved, so the top got repurposed to be

thanks Brian. you are correct, the scale is held in channel not glued. i have not opened the package but i expect this to be not stiff enough to be used on it’s own. i intend to stick it to the AL

I stuck mine down after cleaning the fence with acetone.. never had an issue with it coming loose.. I did not use the spray adhesive either

Not in my lifetime... Brian Lamb blamb11@... www.lambtoolworks.com

I built the legs and stand offs, drilled the mounting holes, laid the top upside down on a table, positioned the legs/base where I wanted it, spot drilled into the table bottom to mark the locations.