开云体育

or just replace 'em? they are under $12.00 each

Maybe there’s a misunderstanding of where the bearing is. Randy, did you expect the shaft to be fixed on the arm, ie, the shaft is bound to the bronze “bushings” (which are actually bearings)?

Friction of wood against metal, works good with my 16' unit. Yes there's a little sag but what does it really matter.?JohnJMK Services

I don't know what you mean, can you re-state it? Note this is functionally the same as what Joel showed in the pic below.? My main point is that it can just as easily be made of scrap wood, ie you

Sam, if it is a NO relay and is testing short you may have found at least one bad part. however, to be sure that the relay is shorted, as opposed to another component in parallel, you will need to

Mac.. can you show a close up of the mounting bracket on the wall?

Mark..while that's a good idea, whats to keep the arm from continuing swinging forward if you want it to stop at a certain area? is there a way to give the arm some resistance so it stays in a

I will when I get something more than parts. Mark

Hi all I love the zci that Ramon made, it works great. Much better than the stock plate. Here's mine without the scoring blade. Thanks again Ramon! Best Larry ________________________________ Sent:

Didn't know those caps came off... thanks, will report back!

I would pry the cap off and see if the contacts have welded themselves closed. If so, open them and clean them up a bit. Steve

So - not sure how reliable this test is as it's done on an installed component but, I've found that one of the relays appears to be closed, whereas the other is open. I'm relatively sure the diagram

Is that a shadow ?

Hello Bob I couldn’t agree more! I’m surprised that sliding table saw manufacturers don’t offer better throat plates. I’ve worked on many different brand sliders...the throat plates are always

A RAS is a very versatile tool. It does many things poorly, and dangerously. It can do one thing well, but other smaller machines do it just as well without the same safety concerns. I'd fogetaboutit

Hi Ramon - Thank you for your post. It's very timely for me.? I've been looking for a replacement throat plate for a Hammer C3 41 I bought last year.? I didn't like the one that came with it. I've

Looking good Mac! Joe in New Orleans

Mac’s 217 is gone to a master. Beautiful saw just don’t need 5 saw 4 is fine This is my current refurbish job a DoAll 16 spf with all the attachments. In basement assembly shop. stripped ,

Sam, A down and dirty way of testing the thyristors (if you are comfortable with a soldering iron) is first remove 1 of them. You need cheapy multimeter with a diode test function. Pins 1 and 2 (anode

Mark, I acquired a 192 last year in real rough shape. I've been working on getting it up and running lately. My hope is it is the general, cut anything saw. It can free up our Feder 540 to be left set