开云体育

Linear rails bolt right into the slots on 8020, so very little fabricating/drilling. Brian Lamb blamb11@... www.lambtoolworks.com

I know a few machine shop guys running that compressor with good success. It makes a load hissing noise when it unloads and stops, that’s been the major complaint. Brian

What do you plan to run with air? Too open ended of a question without some idea of what you want to do. Brian Lamb blamb11@... www.lambtoolworks.com

Yes, you have to have air flow around the compressor and the electric motor. Brian Lamb blamb11@... www.lambtoolworks.com

I've seen the noise issue mentioned several times but plumbing the intake out side only once.? So I will repeat. It helps.? It and can be easy too if near an exterior wall that is not near a

I purchased a Saylor-Beall 80gal/5HP about 6 years ago and it has been great. ?The low RPM, 2 stage is a litter quite too. -Joe

I did this setup a few years back w/ 8020 but mine was bolted to the wall over the K3. Not to long ago I've taken it down to fit my ShopSabre Pro404 in its place and yet to reinstall it. Basically had

All, Thanks for the nice comments about the shop. The 3D scan only took about 40 minutes. I had no idea scanning was that easy. I am giving up Woodworking. I have really enjoyed the past 16 years

Thanks for all the information, I was ready to spend 9k on a Kaeser. I’m going to look for a separate dryer. Thanks, Tom Morris

Tom: I’m going to pile in and strongly recommend against scroll/screw, etc. style compressors. I’ve wasted money on two European units (albeit not Kaeser) but still very high quality machines.

If you still are considering a Kaeser, ?ask about the cost of the recommended routine maintenance.

Every now and then I'll see a table or some enclosure on FB marketplace made out of 80/20 and I keep thinking I should buy it just for the components. Dave

Brian, Imran -- I think both your suggestions are great, will definitely extend the extrusion for some added support and exploring more bearing options. I like these bearings because I'm lazy and I

I came across this scroll type compressor on a Youtube video and was rather impressed with lack of noise and CFM

A 5 hp two stage will deliver 15-17 cfm, 7.5 hp is in the 20 range. My dryer is a Hankison Hi Temp refrigerated. Whether you need the higher input temp depends on how large your tank is and how much

On Fri, Jul 17, 2020 at 03:22:11PM -0700, charlie9g@... wrote: | thanks for the exploded parts diagram.? i would not be surprised if my | machine is like that.? in talking with ron he

Really great looking shop Joe. That 3D tour technology is incredible. Are you hanging it up? Are you hoping to sell it all as a package with the building, or are you selling it separate? I love the

Jason, The heat would kill the compressor? Dave Davies -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

Tom, I have a 80 gallon, 5 HP with a separate dryer. This is in a 4000 foot coop shop with 6 people potentially working at once. It does the job well. Ours isn't the quietest, but we built an

A while back someone had a full shop of Felder Format equipment and sold it as a lot. Are you going to try selling all of your equipment as a single lot? If you could it would certainly be the