开云体育

That will definitely ruin it in short order. Honestly, I’m shocked it’s lasted this long. Brian Lamb blamb11@... www.lambtoolworks.com

brian et al thanks for the tip.? i always leave the planer with either the high or low speed engaged and thus shortened the roller's life.? i always also wondered what the middle notch on the speed

Hi Tom, As John said, these are great if your air requirement is constant and at say 60%-80% of the capacity of the unit you choose. If your air use is intermittent then you are much better off with

Yes what John said. A hobbyist friend in Canada put one in and because he didn’t run it a ton it rusted and was ruined within 18 months. Apparently it needs to get hot enough to boil moisture from

Could be I suppose, mine is a 2001 vintage machine and an AD741. Here is the page from my parts list, shows the two wheels. Brian Lamb blamb11@... www.lambtoolworks.com

IMHO unless your running it constantly all day it's a big waste of money. Screw compressors suck in low use situations.?JohnJMK Services

I'm looking at replacing my compressor with a Kaeser Airtower. It comes in several different sizes of motors from 3hp to 7.5hp. Any recommendations on hp? The air tank is the same size regardless of

Huh. I do have a two-speed planer, but I don't remember seeing a smaller urethane-coated wheel in the chassis. I don't see one in my parts diagram, either, and my sales guy didn't mention one when I

If you have a two speed planer, you will have two wheels. I’ve replaced mine twice now. First set within a few months of new because of some motor issues that allowed the machine to stall. The

Yes find a handy 4 year old my grandson could do it no problem? martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Just replaced mine a few weeks ago. The most annoying part of the job is separating the machines. Replacing the urethane-covered drive wheel is straightforward. Brian mentioned two wheels, but on

It’s the friction wheels that drive the feed rollers. There are two, a large one and a small one. Best to replace both at the same time, the urethane tends to get old and brittle. Also, always leave

not a feed roller sorry it's a tensioner.

well.? i thought the feed rollers needed adjustment.? while doing this it became apparent both rollers were not turning.? ron siebach at felder says it's a urethane covered feed roller.? it is

David B - Very illustrative, thanks for sharing the shots of the setups and the telescopic arm. I think I'll noodle on this a bit and hopefully come up with something workable before I have that first

Panhans sold all kinds of accessories, for many years and used to sHow up on Felder machines in the old days. Saw guards and overheads being one of them martin/campshure/co/llc mac campshure 7412

With my clamps the controls adjustments Are independent Of the position of the angle of the clamp pad and can be positioned for operator ergonomics. Also the lead edge clamp is sent out so the valve

All My mushroom switch Turn my slider off with a knee bump, my pants rubbing against or what ever sometimes Annoying. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

Hi Anthony, i am just starting to use K975 with switch orientation like your saw. i did get used to KF700 saw switch placement but it was more like feeling/searching for it like a blind man with my

That telescopic support on the K975 is so identical to the one on my Panhans I'd think they were made in the same place. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN