开云体育

The markforged (the one used to make this part) has the ability to make the strongest most robust parts of all of the FDM type printers, it can lay carbon fibre filament and the slicing software is

I know this might be an off question and not trying to turn the thread but i love the idea of printing parts like this at home but have not gotten a 3D printer or CNC yet (I am looking at the Camaster

I should correct a bad comment I made about dust collection, what I meant to say there was no mention of dust collection with vac attached or how easy it was to attach a vac. Bag collection is

I don't think they would include a 10" Kapex in a 12" saw review. No mention about dust collection at all. Must be a framer that did the review. I can confirm that the 12" Makita corded is very nice

For the ones interested. Apparently, Bosch GCM12 has been tweaked. Couple of cordless models included. No Kapex, which I also got some emails on from Festool regarding minor upgrades. Imran

I could do that in the next few days, to be honest I think it’s good enough and wouldn’t be worth reprinting. I think you would have to make it taller to really optimize the transition. Probably

Ed the printer is markforged and the material is a nylon with chopped carbon fibre, it actually has the ability to lay in continuous fibre filaments like carbon fibre, fiber glass for uber strength. I

AT LAST? a decent use for those printers~!! ?Good show~!!

Without a blade and after proper alignment of the pulleys, there is not any vibration when only the lower fly wheel spins under power.? It purrs along quite smoothly.? This does not totally

Mark, What material did you print these from? Curious what printer you used as well. Thanks.

My new FB 710 vibrates also.? I haven't had the time to try to isolate the source since I corrected the pulleys mis-alignment issue yesterday (see my FB 710 fly wheel noise thread). The FB 710 spine

I really use the term “bean counting” to refer to “value engineering”, as I suspect most people do. Obviously the accountants aren’t the ones making these decisions, it’s marketing and

DoAll is a fine example of early sheet metal manufactured saw. Very well built I have an 18”. I am not to sure filling column with concrete will eliminate vibration. I have a 36” Oliver and have

Companies use cheap motors and the buyers blame the bean counters. Dave- bean counting right now. ABB makes high and low end motors. ________________________________ Sent: Saturday, February 22, 2020

fwiw, my FB610 is not terrible vibration-wise, but certainly nowhere near as smooth as good old iron or my old DoAll metal saw.? I've never run newer saws like ACM, so can't compare to that.? So I

The only thing that is the same as oliver original is the name they bought for $100,000.00 That’s it!!!! martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

If I had the dimensions, I could model that with a longer, smoother transition for you guys. My printer is packed away as we are remodeling our house at the moment, but I could post the stl file no

I don’t see anything wrong with the machine. The OP used possibly the worst possible combination to test, tall relatively narrow and putting them way off center. Try a 3 foot long piece of 1x6 run

Sorry, I guess I wasn't clear.? I wasn't intending to show a mis-adjusted roller.? The point is that the roller is pushed down on either end by a spring.? At rest, the roller is lower than the

So I just watched the vid and it is a bit much but does it really matter? I have had it happen and I just push on it to straighten it out if I feel like it’s necessary for some reason. Does the