开云体育

I do not see any fences including the round bar for rip fence. ?It does not look that bad for 16 years old. An 80” slider on a 900 series is odd though. Joe in New Orleans

It does not look that bad for 16 years old. An 80” slider on a 900 series is odd though. Joe in New Orleans

Yes, such a disappointment to see fine machinery abused like that. It is definitely a buyer's beware machine. Marlowe McGraw [email protected]> wrote:

Randy,? I have a Forest Dado set that has never been used.? The wax is still on all the teeth.? I had them drilled for my Felder machine before I realized that my older machine is not designed to

Jeez.. whoever owned it sure thrashed it! the switches are all busted off..Those barrel switches are over $300 a piece alone..table top all rusted, inside looks like it's never been cleaned out..etc..

https://www.irsauctions.com/popups/paddle/?lot=411203&auction=YJ321CWFVBQMB8LL1CNKZ5FQ2B5E2O&id=23204 https://www.irsauctions.com/lots/?pg=details&id=23204 -- Jason J. Holtz Furniture 3307 Snelling

Felder here in 2010 had a complaint from a customer about their dado set not cut Melamine good similar to your picture. They gave me the returned set and asked me to do some testing in different

Hmm.. well I think for over $600 for a dado blade..it should cut perfectly clean on whatever sheet material you run thru it.. something is off somewhere. My set is brand new,, first time using it

Hey Randy, I have been very satisfied with the Felder dado sets in solid wood but had similar results in melamine and veneer. I eventually purchased a dado set from Ridge Carbide and have cleaner cuts

I had a similar issue with my set, albeit the larger one and one straight plywood. It went from nice and clean to way too much tearout. I found it was the scooping tooth moved a little and was not

Climb cutting is fine as long as you understand what’s going on. The material needs to be clamped and mechanically moved . Otherwise the material is going for a ride and Possibly you to. Mac,,,

Mac, The riving knife is great, it's my mistake of forgetting that the rip fence is not parallel to the slider. And then only finding after I posted that big email the elite solution of sticking tape

Well - the saw wasn't running backwards. Anyway - no climbcutting here either. David

If all the teeth are there Specifically? the little ones that edge slice the material at the edges and as Mac says it's going in the correct direction Which is easy to get wrong? the first go

Nooo.. uh huh.. No climb cutting going on in my shop.. noosiree...

It is called climb cutting Same direction as scoring blade. Climb cutting is not recommended for hand feeding so be damn careful !!!!! martin/campshure/co/llc mac campshure 7412 elmwood ave.

Ha.. I did the same but caught it before I turned on the saw..? I'll post what the rep finds out..

I own the Felder dado set - and first time I used it I mounted it the wrong way around. The text on mine is written on the side that is supposed to face away from you, when you mount it - contrary to

I recently bought the Felder dado set, which we all know is NOT cheap..I? bought it so I could groove a 1/4"? dado slot for backs of cabinets.. Using it for the first time ever, I have to admit the

I have Mac's clamps on my slider I also use his clamps on my work bench. I have inset lengths of Unistrut into the top. Mac supplied the t nuts. Works a treat.