开云体育

Hi Dan, I have noticed this too on the 230 fence of my CF741. When i do, i pull both fences off and clean everything with a blast of air and a bit of a wipe and it tends to end up spot on again.

I don't think I necessarily agree with the statement "Sliders do work better with less hook" -- if you equate hook with meaning the same as rake angle.? I have tried in one instance using my 10

Thanks Imran, Yes the join in the tape was necessary due to how the table lifts up. I thought i could simply cut it but the two pieces together and it would work, but it turned out that it wasn't

Im using forrest blades. Usa made. ?I like the duraline for xcut and the woodworker ii for ripping. You can ship them the blades to have them retoothed and or sharpened. They will also add the pin

Same here. You are welcome to come to not as sunny Northern California

Anyone can come on down to Sunny Southern California whenever! The New saw (Still unknown to almost everyone!) Still a SECRET, should show up in the next two weeks or so! PK

PK’s observations make sense to me. My comparisons are much more limited, of course. I bought a 15” Powermatic thicknesser with spiral head, after years of the cheapest import I could find. I was

I have a Hammer a3-31 with the silent power spiral head. It is probably the only thing I really like about the machine. My boards come out glassy smooth and I can go right to higher grit finish

PK, it only means we need to do an experiment. Run a board on my machine with the Tersa on one side and you’ll run the other side on the Xylent for comparison :)

I have stayed out of this conversation (maybe I still should!) but here are my observations: Spiral vs Tersa may not be as cut and dry as is being stated. I have had: * Straight knives - Lunchbox

I have packed the filter for my cyclone when the depth of fill indicator fails. The pressure meter goes off the chart when that happens. I periodically take my filter off and clean it on my patio. So

Hi Chris, Hook or rake are used interchangeably. I am not a blade design level expert rather a user who reads and thinks a lot. I have only had blades with negative hook for non-ferrous metals. Here

Thanks Imran, I actually think I have the 50 - Tenryu IW-30050CBD3 300mm not 60. When you say a sliding saw with less hook, do you mean negative? Or just low positive say 0-5°. I do have a scriber -

I had a 30 gal drum on cyclone with 18” woodmaster planer and have RL125 since 2018 with Dual51 equipped with a Tersa head. I filled cyclone filter once maybe twice in 15-16 yrs but have filled

Today I did the mistake of not looking at the dust collector fill indicator when I joint/plane a 18" glue up (I swapped a bag 2 days ago and did minimal milling since then) The entire cyclone and

Has anyone here ever experienced fence plate alignment issues on their f700 series shaper? I’ve had an F700z shaper in the shop since August 22’. It appears that the outboard fence tapers in to

Hi Bryce, I did not do anything, I am glad it is working again. I am impressed that you were able to join two sections of the tape, I would not have likely even given it a go. Imran Malik IAM Wood

Hi Brian, Yes the magnetic tape is definitely tricky to set up after having cut it. You are right about putting it down then cutting it being problematic. That was the problem i ran into the first

Thanks for the reply Imran, I checked the distance between the read head and the tape and it doesn't vary. What i did however just try, was zeroing the read head at 600mm and 800mm and then again at