开云体育

Thanks Mac – sounds like a good endorsement Sent: Saturday, December 14, 2024 11:04 AM To: [email protected] Cc: [email protected] Subject: Re: [FOG] Mirka DEOS 3x4 vs Surfprep

As a sidenote, it is to do Mikra it was in the early 2000s. It was the Atlanta show after the show in the evening time. We’re on top of the hotel in a big hot tub and I was in the pool with a bunch

Hello Mike I was at my neighbor Tim’s last week and he let me try out his Mikra pretty sure it was a 5 inch random orbital not the square pad that you’re asking about but I can tell you it was one

Then it would ride up and down as he moves it from side to side. He already said that his bars are level. Brian Lambblamb11@...

Hey Gentleman I am looking at getting a 3x4 sander. ?I have festool sanders which i like but the 3x4 is taller than i prefer and was looking at these two sanders. ?Does anyone have experience with

Ron, if you adjust the mounting bars so your fence is square does it solve your issue? Regards, Rod

I will look at mine tomorrow to let ya know what I find in the bag of parts that came with it.? I set it up once to validate the top is tapped from the factory. PK

David, This is what I did, I followed your 2 videos and square it to the trajectory of the slider, than attached a dial indicator to the fence and moved it and checked for parallelism between the

Those parts are what bolts the plate to the slider. PK

First off, you should be squaring the crosscut fence to the trajectory of the sliding table, not to the cast iron table edge. Then you can check the motorized fence movement in relationship to the

I was able to fix the issue I had with the swing away device. Next issue I had was the 3 phase EU plug on the machine. Felder sent me the wrong plug (they sent me a receptacle and not a plug, and they

Leveling the flat bars all the way around was the first thing I did Regards, Ron

Very nice JP. I built something similar with Lee Valley stops, the black knob threads into a flat washer in the sliding table T slot to keep the rear F&F jig piece in place. The aluminium tracks are

Hi Jason, no I was referring to making sure that the fence mounting rails are parallel to the table surface. Since the fence is out of square in opposite directions on either side of the blade, it

Ron, When you are talking about adjusting toe in-out, are you referring to drift? Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Hi Ron, try adjusting the flat bars bolted to the sides of the table. I bet if you check they aren't parallel to the top of the table. Regards, Rod.

OK, the nylon nuts adjust so it rests level to the table, also, you can jack up/down the far end to get your fence level to the table. If those set screws go into the slot and hit the steel bar,

The set screws protrude through alright - but they go through the slot in the fence and hit nut (long metal bar) that holds the fence to the knuckle. A Felder tech was in the Seattle area and stopped

I've had a FB610 for over a year and noticed the same issue with the fence being out of square with the table. Adjusting the white colored hex bolts that Brian has pointed out corrected most of the

Michael and Imran, Thanks for the suggestions. I will clean the rails, and also see if moving the slider clears the issue. I will also pay attention to the saw cover to see if there is a correlation