开云体育

Any of the x-roll machines from 2003 onwards.

Email sent on outrigger transport

What year of K700S is the Frits and Franz Fixture for?

Hello everyone, I have a full mortising setup for the AD741, a full mobility carriage w/bar, the outrigger transport thingie, and felder's fritz and Franz - the sawing and clamping jig. All of these

I have found that 3 points of fixing of the short cross cut fence provides perfect stability, even when heavy tenoning on the spindle moulder. And even with Felder's "sloppy" work. Here I show my

The detailed drawings are not well organized or presented, and is missing some information . I recently was checking that I could actually get my new Kappa 450X into my shop, and had to contact Felder

Have you considered sending this to the Felder “wish list” portal?

Kerry, Brett These ideas will work for lay out ideas. While a proper 3d model would make it over the top for space and work flow guess it is not really needed. Maybe someday Felder will release models

I couldn't spend too much time on properly appealing modelling and geometries in Fusion, so I used some generic simple extrusion geometries to the nearest couple inches tolerance, but made sure my

Same answer. David Best - via mobile phone

If it is the same motor as my Hammer J/P, it should be 4HP and 3KW. A 20A breaker should be sufficient (Felder told me I can use either 20 or 30A breaker)

Yes, it is single phase. I don't know the size of the motor. I assume (perhaps erroneously) that the 531s all came with the same size motor. (Unfortunately, the unit itself is in storage and I won't

Hi David, I was suggesting +0/-0.001” (1 mil) not +/-1.0 mm. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

You guys are kidding yourself. +/-1.0 mm would be more sloppy than the original Felder unit. The required spec is +/- 0.01mm or better. What I produced was +/-0.0003-inches or +/- 0.008mm otherwise I

Hi Nate, David be the best to tell us if it is worthwhile to relax the 1/2 mil spec (between the bushing and the counterbore in t-nut), which is hard to meet. I would be worthwhile to know the effect

Are we familiar with any metal show that is willing to produce something with a tolerance of 0.01mm?

Hi Chris, Well I shared this on my FB page and there is interest for 16 pieces. Probably not enough but anyone willing to take up this project? Imran Malik

What size motor does it have? From your details, I assume it is single phase. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

A first post with a simple question: How large an electrical circuit is required for this machine? I should soon take possession and want to know if I need to add another circuit in my shop. My

David: I have been on the same journey and looked everywhere for models. Finally, I got the dimensional drawings of most of the equipment I have, along with the equipment I will order. Then I drew the