开云体育

Well cuteness is wearing off Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Thanks David and Imarn

Not as exiting as a rabbit, but I found a black widow. I start operating a machine, just to find out I have a black spider crawling on my hand. Luckily the machine wasn't running (and I wasn't

?I will start by this pic, taken moments ago: Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

I have the narrow rip capacity machine, 32" or so. I've had my machine up against walls a time or two and always left 49" or so from the blade to any unmovable obstruction on the right so I could

Using an adapter that stays on the BowmouldMaster. David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best

David, how do you connect Bowmaster to the Profil shaper (where has a dust port fence of 140mm)? Do you have a reducer from 140mm to 120mm or do you use a dedicated hose?

Hi David, Thanks for the reference. It never fails, I looked through the index (obviously not carefully enough) and the section 7 in survival guide before asking the question. Completely missed the

120mm. See attached. The Aigner catalog is in the files section. ? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best

Nate, In my case, the hose from my std. shaper hood also fits this larger BMM hood. There is a smaller BMM hood as well and I don’t know it’s port size. Probably mentioned in the survival guide.

Unrelated question, What is the Bowmoulder dust port size?

Imran - from page 226 in the Survival Guide - this would be for KF700, but the F700 is similar. Trunion bolts only exist on pre-X-Roll type machines which I believe is what you have. Check the webbing

Thanks Teboma. Rotating is definitely an option. I should have mentioned that I eyeballed it but my OCD, won’t allow it. Hi Tom, Thanks for sharing your experience. By omission, I assume you have

Hi Imran, I had a similar issue when drilling for the 220mm Bowmould on my TF-130. As Teboma suggests, the easiest solution is to simply rotate the template to avoid existing obstructions. In my case,

You will see references to "Mac's clamps" on here. A member- Mac Campshure- builds pneumatic clamps that are probably the best upgrade as far as for use and safety. I would recommend looking into

You could just rotate the template. ?I know the hood won’t be square to the front of the table, but that’s a solution I think. ?The curved work used with that hood won’t care if the hood is

Finally installing the bowmouldmaster on my KF700. FWIW, it is the larger of the 2 hoods supplied by Aigner. I used the template provided by Aigner to locate the 2 holes I need to drill and tap

I would like to pose a question to the group regarding the comments above…. I am in a small space with a K700S, and every inch of usability that I remove from the right side of the blade I pick up

Sign your posts with a name so we know who you are. David Best - via mobile phone

This is how I recommend you set up your rip fence for use as both a conventional rip fence and as a bump stop: rip_fence_as_parallel_fence-AzG84419q1i78vGv PDF Document · 568 KB DM me if you have