开云体育

Hello, I have an older AD741 with electronic height adjustment. Was planning some boards on edge to get to perfect 2" width, which I've done many times. At the 2.000 setting the board was about 1/16"

Something weird here was not supposed to be in my last text martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

I have a pleaded filter in my dusthog something weird here and I just set it up for routine maintenance and have somebody clean it every three or four months so the simplest way to do it so you’re

Jonathan, no worries. Just mentioned it in case it helps. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Imran, my tightening nut for the thrust bearing is good. I'm happy with the method I now use, If I ever get time I might make a better looking model. [email protected]> wrote:

Reading all this, after I finish my current window project I may need to do a full clean out, gasket replacement, etc. my RL is 2004 vintage and needs a little tlc. Thanks for getting me excited for

Hi Jonathan, Have you try the nut Mikelis mentioned earlyto tighten the mechanism? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hi Imran, there is a small amount of play in the indexing pins but more in the adjuster......Im happy to blame the european union for it ?but, in mainland europe we do use the same side as the US

Hi Jonathan, Thanks for sharing. Just to be clear, are you experiencing play in the adjuster or from the pins indexing in the table holes? As I mentioned earlier, it is the later for me and I push LHS

Kory, no experience with the SCM offering but I can say on my two KF700s there is play on the fine adjuster (0,5mm) until you tighten the two kip levers. So when dialing in on the fine adjuster you

Gary, thanks for the detailed follow-up. I have been wondering how your project was evolving. Looking at and reading about how your machine is constructed, I would have to agree that it’s like no

Members, i apologize if this is not the right forum for the question. Does anybody have an EGL (or EGL) with a bracket for my KF700 that would like to sell? Please let me know. Eduardo.

Here’s a status update on my RL160 filter change adventure: - My 2008 RL160 is apparently different from all other RL160s that I am aware of. My RL has a single opening, on the narrow side where

Kory, Joe Calhoun has retrofit position indicators onto some of his shaper components (notably the feeder) to provide repeatability. I’ve intended to retrofit my Felder 230 shaper fence with a

I did the DRO addition to the shaper fence... but it's complicated and required shipping the customer's fence here to be machined and modified. Not something i want to get into again honestly.? I

Hi Mikelis, I reread my msg and it was poorly stated. Yes, I was referring to the slop between the holes in cast iron table and the indexing pins under the hood. Imran

How hot the motor runs seems to impact bearing life. There are high temp grease bearings for motors but I don't know if they are universally used. I do know my Italian motors run from very warm to

Hi Kory, The Felder "230" fence currently available on the F700 and F900 shapers is sturdy and stable once secured, but it can be a bit fussy to set up. The in-feed fence is fixed relative to the

Imran, have you tried tightening the nut for the thrust bearing on the microadjust threaded rod? Mine had multiple mm of slop, but after tightening, that problem has gone away. That said, the pins

I have a plan to add DRO to the shaper on my KF700. I am just waiting to build my tenoning fence and install bowmouldmaster so I am sure what I do is not going to be in the way. I am glad to have the