开云体育

This is one of the arguments for running a VFD per machine even if you have a 3-phase source. You can program the start ramp.

I think the statement that you can "run a 15HP machine on a 10HP Phase Perfect" should be taken with a grain of salt.? In most cases, this is possible.? With the exception of a dust collector, most

On Thu, Jul 20, 2023 at 11:13 AM Aaron Inami <ainami@...> wrote: > I would check underneath your slider to make sure there isn't any material > blocks in the sliders that would prevent you

I would check underneath your slider to make sure there isn't any material blocks in the sliders that would prevent you from pulling the slider all the way back.? Felder will ship the slider with

Just needed a bump, sorry?

Ed, If you want to email me I can walk you through my setup. For the 10hp PP you need an 80 amp breaker, 15hp PP is a 125 amp breaker and the 20hp is 160 amp (all of this is in PP's manual).? I did a

Hi all just started with my brand new kf700sp doesn’t appear that the slider locks in the rear position. Is this standard?

I reached out to Phase Perfect a few weeks ago because I was considering making the jump to 3-phase.? Unfortunately, it doesn't seem like it's worth the overall cost and investment (due to how much

My profile 45z finally made its way to the port. Hoping to get it delivered in the next month. In preparation, I need to get a Phase Perfect wired up since this is my first three phase machine. I was

Agreed and blocks and. Good 2x4 will pop that thing up quick martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@...

Could probably use any decent engine hoist and slings... Brian Lamb blamb11@... www.lambtoolworks.com

?Sounds right. Just not sure what happens with the tipping and weight but cribbing with 4x4 or 6x6 would be the safest. Here is a picture of a motor exchange these are 6x6 shaper is 2500# You can do

Not sure if this would work in your case. You can lift fairly heavy things with those heavy duty, ratchet, cargo tie down straps. One method, to tip it on its side, might be to run some of those

Thank you, I will check that out today.

Dave. I did ask a Felder Tech. Answer: Rent a floor jack to tip it up and set it down on blocks just high enough to get my arms and shoulder under it to do the work. The work goes something like this.

Dave i think that is the best method . martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell608-824-0023 fax airtightclamps@... airtightclamps.com

Maybe ask a Felder tech how best to make the swap. Dave Davies [email protected]> wrote:

I haven’t done this on the new style. The old style from memory it sat on the body and not the table . So I would be cautious tipping at an angle. Secure blocking might be safer lifting with pry bar

Wade, Yes it has Felder's standard warranty and they say it's expired. Regardless, that they sell a machine with inaccessible parts that fall off and then want to charge me to repair it is a bit much.

Did you look in the setup directory? /g/felderownersgroup/files/General%20Information/Machine%20setup