开云体育

thanks , Wade !?? I will check it out.??? cheers......

Andy - thanks so much for taking the time to measure. Much appreciated! I had subscribed to the extreme woodworker channel previously. The channel has been super helpful. I’m mostly using a tracksaw

Hi Rich M., I do not have it. But after measuring a few of my larger machines and some equipment. And an AD941 coming in June, it sure looks versatile. I also like the turning radius, it has more than

Hi Wade -??? Do you have this adj width jack ???? I've been procrastinating, need to get a jack for the Hammer C3 , sander unit, etc.?? Adjustable looks great if it works well. thanks,???

When trying to decide on which pallet jack size is best, this may be the perfect choice. Two in one pallet jack. Adjustable Width Pallet Jacks in Stock uline.com

Hi Andy, just measured them and they are 10mm bolts on the feet. I definitely didn't open up the holes so either 10mm or 3/8 inch would work for the leveling feet. The mobility kit uses a bracket on

I’ve posted about this before. From a spec standpoint, the Felder edgebanding machines stack up well. That said, production edgebanding machines are very maintenance intensive, especially if run

I would plump for the Felder unit as it has an interchangeable glue pot. The achilles heel of these machines in my experience is the necessity of keepinhg them scrupulously clean. Tthe interchangeable

All 700-series machines have 11mm unthreaded holes in the base for installation of leveling feet. So without enlarging the holes (which some uses have done with a step-drill when the machine is

Dan, what did you end up going with? We’re in the same boat right now choosing between these two machines and the Minimax. Anybody else have opinions?

Hey Andy, Any chance you can confirm these are M10? I need to order some leveling feet for my C3 before it arrives, I can call Felder support as well if that’s too much trouble. I ordered the

This thread piqued my interest one man show here and could use hold downs for cabinet boxes.? Pricing from Martin is H330 lift table $3,200, H350XL $4690, vacukar $8300-$8900, vaculift which is

For my C3-31 (which is lighter than your CF) I use leveling feet (it takes 6) and a trolley jack. If you are moving it between two marked locations I would use your current method and just have two

Hi all I am planning on fitting levelling feet to my CF 741. When I first set up the machine I marked the chassis feet location on the floor and set up and levelled some custom shims. I then placed

The China wind turbine blade is pretty amazing, too.? A whole different set of challenges.? A 230 foot hollow material sticking up in the air compared to a 700,000 lb piece of metal generator rotor,

Thanks John , I am happy with the flat wheel on euro style saw with wider blades I run a 1” carbide most all the time Rapid/Agazoni 640. My Oliver 36 vintage 60’s has a slight crown run a 1.5 “

Greg, I used this glue to fix the Felder tires to my FB540. It has a snotty consistency which in retrospect contributed to the inconsistent tire height. There is a spray pre-cleaner that is used with

Mac, I think you are right to have a flat tire and orient the blade at the edge with the teeth overhanging the edge of the wheel. The Felder manual instructs this method. But the manual also says to

This video from China is also pretty impressive. Wind turbine blade. https://youtu.be/cxFfZGthRGQ <https://youtu.be/cxFfZGthRGQ> Roger

These are called Superloads. When shipments are too big/too heavy for trucks they go by rail. When they are too much for rail they go back to the roads with rigs like this. Some of the rigs, like